Temperature/stress Dependence of Stress Rupture Behavior and Deformation Microstructure of an Advanced Superalloy for Additive Manufacturing
Wei Song,Junying Yang,Jingjing Liang,Nannan Lu,Yizhou Zhou,Xiaofeng Sun,Jinguo Li
DOI: https://doi.org/10.1016/j.jmst.2024.03.072
2025-01-01
Abstract:A self-developed crack-free advanced superalloy ZGH451 fabricated by direct energy deposition (DED) was applied to investigate the microstructure evolution, stress rupture behavior, and deformation mechanisms at moderate-high temperatures and high-low stress conditions. The high Ta/Al ratio induces large misfit lattice stress and low stacking fault energy of alloy, resulting in approximate cubic gamma ' phases in dendrites and the formation of initial dislocation tangles. After the stress rupture test at 760 degrees C/780 MPa, high content cubic gamma ' phases, small size of voids as well as preserved dislocation tangles are observed, showing stable structures with high-stress rupture resistance. High content and suitable size of cubic gamma ' phases, initial dislocation tangles, and L -C locks hinder the dislocation motion, which decreases the minimum strain rate and prolongs life significantly, forming four stress rupture stages. Hence, the deformation mechanism is determined by dislocation piled-up on gamma / gamma ' interface, formation of stacking faults in gamma ' phases, and dislocations shearing gamma ' phases. However, the microstructure exhibits uneven structures composed of large sizes of rafted gamma ' phases and voids at 980 degrees C/260 MPa. The rafted structure and high temperature provide continuous channels and enough energy for dislocation motion, resulting in the increase of minimum strain rate, decline of life, and typic three stress rupture stages, even though there are obstacles to dislocation movement caused by dislocation networks. The deformation mechanism transforms to form dislocation networks on gamma / gamma ' interface and dislocations shearing gamma ' phases. Besides, the decomposition of carbides on GBs also depends on temperature, which decomposes into harmful chain-like M23 C6 carbides at moderate temperatures and reinforced granular-shaped M6 C carbides at high temperatures. The applied stress always decreases mechanical properties due to its degradation of microstructure induced by elongating the precipitates and defects. (c) 2024 Published by Elsevier Ltd on behalf of The editorial office of Journal of Materials Science & Technology.