Influence Mechanism of Slow Cooling Treatment after Homogenization on Hot Deformation Behavior of a New Nickel-Based Superalloy

Yushuo Li,Yanwu Dong,ZhouHua Jiang,Shuyang Du,Kean Yao,Yong Wang,Xinwei Wang
DOI: https://doi.org/10.2139/ssrn.4264093
2022-01-01
SSRN Electronic Journal
Abstract:For a new nickel-based wrought superalloy, hot working in the γ + γ' dual-phase region is inevitable due to it’s extremely narrow γ single-phase region. However, the fine and coherent γ' particles precipitated in the dual-phase region can significantly increase the difficulty of hot deformation. In this study, slow cooling treatment after homogenization was adopted to improve the hot workability of the alloy in the dual-phase region, and its influence mechanism was analyzed by electron backscattered diffraction (EBSD), transmission electron microscope (TEM) and scanning electron microscope (SEM). The results revealed that with the decrease of cooling rate, continuously coarsened γ' particles and widened γ channel were beneficial to form serrated grain boundaries (GBs) and weaken the pinning of dislocations and GBs, thus promoting the discontinuous dynamic recrystallization (DDRX) and continuous dynamic recrystallization (CDRX) of the γ matrix. Meanwhile, slow cooling treatment is beneficial to increase the relative fraction of twins by affecting local stress concentration and local GB migration rate, which can further accelerate the DRX of γ matrix. Notably, when the cooling rate is extremely low, the ultra-coarsened γ' precipitates can separate or seal γ matrix. DRX grains and twins cannot pass through the γ' precipitates, thus the grain microstructure was significantly refined and the twin fraction decreased. Moreover, the ultra-coarsened γ' precipitates were also deformed along the compression direction and underwent DRX, while the γ' precipitates had slower DRX due to their ordered structure and extremely high strength, which reduced the overall DRX degree of the alloy.
What problem does this paper attempt to address?