Abstract:Solid oxide fuel cell (SOFC) provides a new method for clean and efficient conversion and utilization of hydrocarbon fuels due to its high fuel flexibility. The utilization of biogas fuel through direct internal reforming (DIR) allows for a simplification of the SOFC system since no external reformer appears strictly necessary. Despite its considerable convenience and potential, at present, direct internal dry reforming is still not considered as a competitive process for commercial application, which is limited by the reaction difficulty and high risk of carbon deposition. To address the problem, in this study, conventional Ni-yttrium stabilized zirconia (YSZ) anodes of SOFCs are modified by two methods, i.e. Ce0.9Gd0.1O2-δ (GDC) infiltration and a Ni-GDC reforming catalytic layer. A comparative study between the modified cells and the bare cell is made under operation with humidified H2 and simulated biogas. Both of these two modification methods lead to a slight but acceptable decrease of the cell performance under humidified H2. In the case of simulated biogas, results show that GDC infiltration is only beneficial to the cell performance with very low or very high CO2/CH4 molar ratio. While with a moderate CO2/CH4 ratio of 0.5–1.5, GDC infiltration instead results in a decrease of cell performance. However, the cell modified by a Ni-GDC catalytic layer shows superior performance towards the direct utilization of simulated biogas than the bare one and the one modified by GDC infiltration. The anode modification by a Ni-GDC catalytic layer can also improve the stability of the cell under simulated biogas, which is verified under different operating currents, although serious carbon deposition is detected in the catalytic layer afterwards.

Investigation of the Anode Reactions in Solid Oxide Electrolyte Based Carbon Fuel Cells

Studies on the Carbon Reactions in the Anode of Deposited Carbon Fuel Cells

Anodes for Carbon‐Fueled Solid Oxide Fuel Cells

Research Development on Novel Anode of Solid Oxide Direct Carbon Fuel Cells

Effect of Contact Type Between Anode and Carbonaceous Fuels on Direct Carbon Fuel Cell Reaction Characteristics

Mechanism for carbon direct electrochemical reactions in a solid oxide electrolyte direct carbon fuel cell

Research and Development of Solid Oxide Direct Carbon Fuel Cell

In-situ Analysis of Anode Atmosphere in a Flat-Tube Solid Oxide Fuel Cell Operated with Dry Reforming of Methane

Experimental Characterization and Elementary Reaction Modeling of Solid Oxide Electrolyte Direct Carbon Fuel Cell

Investigation of Carbon Formation on Ni/YSZ Anode of Solid Oxide Fuel Cell from CO Disproportionation Reaction

Performance of Solid Oxide Fuel Cells on H-2, Nh3 and Hydrocarbon Fuels

Electrochemical Characteristics and Carbon Tolerance of Solid Oxide Fuel Cells with Direct Internal Dry Reforming of Methane

Review of Anodic Reactions in Hydrocarbon Fueled Solid Oxide Fuel Cells and Strategies to Improve Anode Performance and Stability

Solid Oxide Fuel Cells Fueled by Simulated Biogas: Comparison of Anode Modification by Infiltration and Reforming Catalytic Layer

Effects of Coal Syngas Major Compositions on Ni/Ysz Anode-Supported Solid Oxide Fuel Cells

Structurally modified coal char as a fuel for solid oxide-based carbon fuel cells with improved performance

Anode Catalysts for Solid Oxide Fuel Cells That Run Directly on Hydrocarbon Fuels

Effects of Syngas Components on the Carbon Formation in Planar Solid Oxide Fuel Cell

A Comparative Study of Different Carbon Fuels in an Electrolyte-Supported Hybrid Direct Carbon Fuel Cell

Research of Carbon Deposition Formation and Judgment in Cu-CeO2-ScSZ Anodes for Direct Ethanol Solid Oxide Fuel Cells

Numerical Analysis of the Possibility of Carbon Formation in Planar SOFC Fueled with Syngas