Abstract:An integrated curing simulation methodology considering resin flow and compaction. Computational methods provide effective tools for the prediction of the curing behavior of composites, especially for large‐scale complex composite structures. The flow‐compaction analysis during curing receives insufficient attention in current studies. In this work, an integrated framework considering the heat transfer, the cross‐linking reaction, the flow and compaction, and the stress–strain module is established. A comprehensive resin flow termination criterion is proposed. L‐shaped composites with a stacking layer of [45/90/−45/0]s were fabricated, and the good agreement between the experimentally measured and the numerically predicted contour data validated the current model. Compared with Hubert's model, the prediction accuracy of the thickness and fiber volume content increases by 4.24% and 3.92%, respectively. Correlation analysis between the fiber volume ratio predicted by numerical methods and experimental results (94% for this method, −41% for Hubert's model) demonstrates the well‐capture of nonuniform fiber distribution in curved composites for the current strategy. The overall framework provides an accurate and promising tool for the prediction of the curing behavior of complex composite components. Highlights An integrated numerical methodology is proposed considering the resin flow and compaction. The viscosity‐temperature coupled feature of resin is considered in the permeability coefficients. A comprehensive resin flow termination criterion is proposed for an accurate prediction. The resin content, thickness, and spring‐in angle of L‐shaped laminates are characterized. The good correlation between the experimental and numerical results validates this method. Compared with the model proposed by Hubert, the prediction accuracy improves.

A new analytical solution for spring-in of curved composite parts

A Thermo-Viscoelastic Analytical Model for Residual Stresses and Spring-in Angles of Multilayered Thin-Walled Curved Composite Parts

An Improved Analytical Solution For Process-Induced Residual Stresses And Deformations In Flat Composite Laminates Considering Thermo-Viscoelastic Effects

Design and analysis of the mandrel structure for a composite S-shaped inlet

Study on Cure-Induced Residual Stresses and Spring-in Deformation of L-shaped Composite Laminates Using a Simplified Constitutive Model Considering Stress Relaxation

Experimental and analytic analysis of the structure parameters on process-induced distortions of V-shaped composite parts

Analysis of Cure-Induced Deformation of Asymmetric C-shaped Composite Parts

Modeling on the Effect of Automated Fiber Placement Induced Gaps in Curved Composite Laminates

Spring-in behavior of woven carbon fiber/polycarbonate thermoplastic composites

Process-Induced Deformation of L-Shaped Laminates: Analysis of Tool–Part Interaction

An Amendment Method for Stress and Strain of Double-Curved Laminated Composite

Numerical Simulation on Process-Induced Deformation of Autoclaved V-shaped Composite Parts

A Model on the Curved Shapes of Unsymmetric Laminates Including Tool-Part Interaction

Influence of fiber volume content and resin-rich area on process distortions of V-shaped composite parts

Simulation of Fiber Reinforced Composite Materials Mold Filling Process and Mechanical Properties Analysis

Bi‐stable Cured Shape of CFRP Variant Structures with Asymmetric Layup: Rapid Prediction and Inverse Design

Experimental and numerical analysis of new thermoplastic composite mandrels

Viscosity‐coupled curing simulation model for L‐shaped composites considering flow and compaction

Cured Shapes of Bi-stable CFRP Composite Laminates with the Side Length Exceeding a Critical Value

An analytical formulation of unidirectional composite curved beam with out-of-plane fiber waviness under bending

Effect of processing method on the spring-in of aircraft ribs