Abstract:3D-printed carbon fiber composites hold significant potential in aerospace applications because of their lightweight, high strength and complex structure fabrication capabilities. However, additive manufacturing characteristics such as high porosity, anisotropy and continuous fiber content significantly affect the mechanical properties of printed parts. The aim of this study is to investigate the influence of hybrid printing of short and continuous carbon fibers on the mechanical properties and failure mechanisms of composites and to develop a model to predict elastic properties considering porosity. First, mechanical testing and characterization of short and continuous fiber reinforced polyamide (nylon) print filaments are performed. The results indicate that the elastic modulus and ultimate strength of continuous carbon fiber filaments reach 60 GPa and 1500 MPa, respectively, while the strength and elastic modulus of short carbon fiber filaments reach 60 MPa and 1 GPa, respectively. Then tensile specimens with different continuous fiber orientations and different continuous fiber placement sequences are printed and tested using a multi-material 3D printing technique. The specimens are characterized before and after testing using scanning electron microscopy and microscopy to assess the porosity and failure mechanisms of specimens with different configurations. The results show that the mechanical properties of the printed parts are much lower than those of the print filaments, which proves the serious negative impact of the material extrusion process on the mechanical properties of the printed structural parts. Finally, an analytical method for predicting the elastic behavior of printed composites is developed by introducing the porosity factor in the volume-averaged stiffness model. For continuous and short fiber filled composites with different fiber contents and printing orientations, the predicted results are in agreement with the experiments, and the prediction error is greatly reduced from 30% to less than 5%.

Experimental and numerical analysis of new thermoplastic composite mandrels

Shape Memory Polymer S-shaped Mandrel for Composite Air Duct Manufacturing

Design and analysis of the mandrel structure for a composite S-shaped inlet

Experimental and Theoretical Studies on 3D Printed Short and Continuous Carbon Fiber Hybrid Reinforced Composites

Research Progress in Numerical Simulation of Fiber Reinforced Thermosetting Resin Matrix Composites Molding Process

Analysis of curing deformation for resin matrix composite T-shaped stiffened panel

Prediction of shape distortions in thermosetting composite parts using neural network interfaced visco-elastic constitutive model

Rubber mandrel design suitable for manufacture co-cured hat-stiffened composite panel with large curvature by auto fiber placement technique

Experimental and numerical analysis of the consolidation process for additive manufactured continuous carbon fiber-reinforced polyamide 12 composites

Integrated computational modeling of large format additive manufacturing: Developing a digital twin for material extrusion with carbon fiber-reinforced acrylonitrile butadiene styrene

Investigation on the mold‐less curing process of 3D printing continuous carbon fiber reinforced thermoset composites based on thermoplastic shells constraint

Simulation and Optimization of Mandrel-Heating Process for Composite Shells Using Internal Heat-Curing Method

An experimental validation study of a numerical modeling approach to predicting post-consolidation dimensions of thermoplastic composites

Process evaluation, tensile properties, mathematical models, and fracture behavior of 3D printed continuous fiber reinforced thermoplastic composites

Inherent relationship between process parameters, crystallization and mechanical properties of continuous carbon fiber reinforced peek composites

Characterization Approach for Compression Molded Discontinuous Fiber Thermoplastic Composites

Thermo-Chemo-Mechanical Modeling of Residual Stress in Unidirectional Carbon Fiber-Reinforced Polymers during Manufacture

Technology and mechanical properties of reinforced continuous fiber 3D-printed thermoplastic composite

Mechanical and Material Characterization of 3d Printed Continuous Fiber Reinforced Photopolymer Matrix Composites

Structure Design on Thermoplastic Composites Considering Forming Effects

Preparation and Evaluation of the Tensile Characteristics of Carbon Fiber Rod Reinforced 3D Printed Thermoplastic Composites