Abstract:Publication date: 2 October 2023 Source: Key Engineering Materials Vol. 957 Author(s): Carlos Rodríguez-Mondéjar, Alvaro Rodríguez-Prieto, Ana Maria Camacho The development of composite materials has meant, over the last few decades, a challenge for research in relation to the search for new ways of manufacturing. Currently, a wide variety of materials and processes have a high degree of development and industrial applications, but the potential for improvement in this area promotes the search for new systems that allow obtaining products with better mechanical characteristics and better manufacturability. Within this framework of the development of processes and applications, the following combination of manufacturing technologies is proposed: thermoforming and overmolding of carbon fiber reinforced thermoplastics with continuous and short fibers respectively. The aim of this work is to provide a hybrid technology to manufacture sandwich panels whose stiffening core geometry can be highly optimized based on the load requirements considered in the design of the product of interest. The proposed process consists of the prior shaping by thermoforming process of a continuous fiber-reinforced thermoplastic laminate on one of the surfaces of the manufacturing mold that will later be used for injection of the core structure with a counter-mold adapted for this purpose. The injection of the short fiber reinforced thermoplastic will be carried out in such a way that one of the surfaces of the resulting cavity is directly in contact with the previously formed laminate, giving rise to an overmolding. After this operation, a closing laminate will be formed that will give the panel the desired resistance. A detailed analysis of the different stages of this process is necessary, especially with regard to the processing parameters (e.g. injection temperature, pressure, polymer velocity, and interface temperature), orientation of the fiber resulting from the injection process, the adhesion of the polymer between stages, and the geometric limitations of considered sub-processes. The analysis is performed using a finite element method (FEM) software and analytical approaches.

Rubber mandrel design suitable for manufacture co-cured hat-stiffened composite panel with large curvature by auto fiber placement technique

Design and analysis of the mandrel structure for a composite S-shaped inlet

Shape Memory Polymer S-shaped Mandrel for Composite Air Duct Manufacturing

Preparation and Validation of a Longitudinally and Transversely Stiffened Panel Based on Hybrid RTM Composite Materials

Experimental and numerical analysis of new thermoplastic composite mandrels

Experimental and numerical studies on two-point incremental forming of woven fabric composite sheet

Enhancing the Forming Accuracy of CFRP through a Global Compensation Method by Introducing an Optimal Profile

Design and manufacture of mould-free fibre-reinforced laminates with compound curvature

Structure Design on Thermoplastic Composites Considering Forming Effects

Improved Structural Efficiency in Composite Manufacturing via Hammered Printing for Large-Curvature Fiber Paths

The Preparation and Properties of Novel Structural Damping Composites Reinforced by Nitrile Rubber Coated 3‐D Braided Carbon Fibers

Analysis of curing deformation for resin matrix composite T-shaped stiffened panel

Preparation Optimization of CFRP and EPDM Composite by the Co-Curing Method

Feasibility study of an integrated pre‐curing and forming process for 6061 Al alloy and carbon fiber hybrid composites

A novel post‐forming method for fully cured thermosetting composite parts: Prediction and investigation

Resin Infusion Between Double Flexible Tooling: Evaluation of Process Parameters

Active control of cure-induced distortion for composite parts using multi-zoned self-resistance electric heating method

Novel Approach toward the Forming Process of CFRP Reinforcement with a Hot Stamped Part by Prepreg Compression Molding

CF Reinforced Thermoplastic Hybrid Process Proposal for the Optimization of Sandwich Panels Stiffness and Processability

Preparation of High-Performance Carbon Fiber-Reinforced Epoxy Composites by Compression Resin Transfer Molding

Micro-Injection Molding of Carbon-Fiber-Reinforced Plastic (CFRP)/Polymethyl Methacrylate (PMMA) Composite Components