Abstract:This study describes the design and development of a low-noise and process variation-tolerant potentiostat readout integrated circuit optimized for electrochemical sensors in biomedical applications. Accurate and fast detection by electrical signals, particularly for pathogenic viruses, is critical in the biomedical field. Therefore, design criteria for biosignal sensing architectures emphasize high precision and low noise to ensure high reliability. The proposed potentiostat readout circuit integrates key components, such as a control amplifier (CA), transimpedance amplifier (TIA), 12-bit R-2R digital-to-analog converter (DAC), 12-bit SAR analog-to-digital converter (ADC), relaxation oscillator, clock divider, current/voltage reference, and serial peripheral interface. The chopping technique is adopted to mitigate the 1/f noise. The low-frequency noise is substantially reduced by implementing chopper stabilization in the CA and TIA. High-precision DACs are required because various waveforms, including dc, triangular, and ramp functions, are utilized for electrochemical measurement. In this design, dynamic element matching is applied to DACs with high precision. This approach can reduce the intrinsic mismatch in the R-2R DAC, thereby improving the offset error and spurious-free dynamic range from −1.4 least significant bit (LSB) and 74 dB to −0.5 LSB and 79 dB, respectively. The readout circuit was fabricated using a standard 180-nm CMOS process and can measure sensor currents in the range of A, achieving a linearity performance of 0.9998. The input-referred noise, as measured, is 6.65 pARMS in the frequency range of 0.5–400 Hz, and the total current consumption of the circuit is A at a supply voltage of 3.3 V.

An Oscillator-Based CMOS Magneto-Sensitive Biosensor with a Low Noise and Low Temperature Coefficient LDO Regulator

A Low-dropout Regulator with Low Quiescent Current and High Stability

An Oscillator-Based Cmos Magneto-Sensitive Biosensor with In-Situ Switched Capacitor Calibration Scheme

A Novel Fully On-Chip CMOS Low-Dropout Linear Regulator with Ultra Low Noise

Highly Stable Low-Dropout Linear Regulator with Temperature Compensation

An All-Digital CMOS Temperature Sensor with a Wide Supply Voltage Range.

Low-dropout regulator with no off-chip capacitor and ultra low power consumption

Design of CMOS magnetic sensor integrated circuit

A CMOS Magnetic Sensor Integrated Circuits Based on the Synchronized Sampling Function of Sector MAGFET

A CMOS Magnetic Sensor Based on Synchronous Sampling Function

A CMOS Sectorial Split-Drain Magnetic Sensor IC

An Oscillator-Based CMOS Magnetosensitive Microarray Biochip with On-Chip Inductor Optimization Methodology

A Capacitor-Free Cmos Low-Noise, Low-Dropout Regulator for Capacitive Micro-Machined Accelerometer Application

A Low Noise Bandgap Reference Voltage Source for CMOS Temperature Sensors

A Sub-µg Bias-Instability MEMS Oscillating Accelerometer with an Ultra-Low-Noise Read-Out Circuit in CMOS

An Integrated Low 1/f Noise and High-Sensitivity CMOS Instrumentation Amplifier for TMR Sensors

Design of Low-Offset Low-Power CMOS Amplifier for Biosensor Application

Ultra-sensitive magnetic field sensor based on a low-noise magnetoelectric MEMS-CMOS oscillator

Low-Noise and Process Variation-Tolerant Readout Circuit for Electrochemical Sensors

Ultrasensitive modulated magnetoelectric sensors and low noise readout circuits for DC and very low frequency weak magnetic signal detection

A Low Noise, Fast Set-Up Low-Dropout Regulator in 65nm Technology