Abstract:Partial discharges (PD) are the most common and harmful threat to the health of electrical insulation of high voltage (HV) and high field (HF) equipment. The occurrence of PD activity in HV and MV equipment is at the same time a cause and a sign of insulation degradation that may eventually result in the breakdown of the HV power equipment. For the safe and reliable operation of HV power equipment, continuous PD monitoring needs to be conducted conveniently to prevent any unplanned power outages and damage to electrical power equipment. The ultra-high frequency (UHF) PD measurement method has been widely used as an effective technique to detect PD activity on HV power equipment due to its non-invasive principle. To enable PD detection accuracy, there is still a need for more sensitive PD sensors that can assist the UHF PD monitoring system by suppressing ambient background noise and low-frequency electromagnetic interferences from telecommunication such as GSM signals. To tackle the sensitivity issues, this article presents a new design of ultra-wideband (UWB) microstrip patch antenna that is capable of effective suppression of low-frequency interference signals. The proposed antenna, designed, simulated, and optimized using the CST Microwave Studio software, has a bandwidth of 3.3GHz, below -10dB, in the operating frequency range of 1.2GHz-4.5GHz. The prototype of this antenna, printed on an FR4 substrate of a thickness of 1.6mm and a dielectric constant of 4.4, featuring a compact size of 100mm $\times100$ mm $\times1.6$ mm, was implemented to detect PD through laboratory experiments. This paper shows that the designed UWB antenna has high sensitivity, good noise rejection and it is, therefore, a promising candidate sensor for PD detection on HV equipment.

Study on Ultra-High Frequency Partial Discharge Simulator and Its Propagation Characteristics

Research on the Calibration Methods for Ultra-high Frequency Partial Discharge Detector

Partial Discharge Wideband Full-Band High-Gain Resonant Cavity UHF Sensor Research

The Frequency Range Selection for Measurement of Partial Discharge in Transformer Oil with UHF Method and Interference Suppression

Location of PD by Searching in Space Using UHF Method

Study on the Ultra-High-frequency Sensors for PD Detection in Power Transformer

Experimental Investigation on High Frequency Sensing Characteristis of Floating Type Partial Discharge

Field test on a transformer for partial discharge location by uwb-rf method

Simulation Analysis on the Attenuation Characteristics of Partial Discharge Ultra-high Frequency Signals in GIS

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse

Calibration Technology and Application of Ultrasonic Sensor for Partial Discharge Detector

Design and Implementation of Ultra-Wide Band Antenna for Partial Discharge Detection in High Voltage Power Equipment

Detection and Identification Technologies of Wide Band Partial Discharge

A novel calibration method for PD measurements in power cables and joints using capacitive couplers

Research on Miniaturized UHF Sensing Technology for PD Detection in Power Equipment Based on Symmetric Cut Theory

Influences of Center Frequency and Bandwidth on UHF PD Detection for Transformers

Minimally invasive nephron‐sparing surgery for renal cell cancer

Investigation of the UHF Partial Discharge Detection Characteristics of a Novel Bushing Tap Sensor for Transformers

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis