Abstract:Partial discharge (PD) detection is an effective method for finding insulation defects in HV and EHV power cables. PD apparent charge is typically expressed in picocoulombs (pC) when the calibration procedure defined in IEC 60270 is applied during off-line tests. During on-line PD detection, measured signals are usually denoted in mV or dB without transforming the measured signal into a charge quantity. For AC XLPE power cable systems, on-line PD detection is conducted primarily with the use of high frequency current transformer (HFCT). The HFCT is clamped around the cross-bonding link of the joint or the grounding wire of termination. In on-line occasion, PD calibration is impossible from the termination. A novel on-line calibration method using HFCT is introduced in this paper. To eliminate the influence of cross-bonding links, the interrupted cable sheath at the joint was reconnected via the high-pass C-arm connector. The calibration signal was injected into the cable system via inductive coupling through the cable sheath. The distributed transmission line equivalent circuit of the cable was used in consideration of the signal attenuation. Both the conventional terminal calibration method and the proposed on-line calibration method were performed on the coaxial cable model loop for experimental verification. The amplitude and polarity of signals that propagate in the cable sheath and the conductor were evaluated. The results indicate that the proposed method can calibrate the measured signal during power cable on-line PD detection.

A Novel Noise Elimination Method for PD Measurement of On-Site MV Cable Using Frequency-Tuned Resonant System

Radio-frequency Detection of Partial Discharge in Power Cable Joints

A Novel Variable-frequency Resonant System for Partial Discharge Detection of XLPE Cables

A Novel Partial Discharge Locating System for 10-Kv Covered Conductor Lines in Distribution Network

Implementation of A Novel Double-Side Technique for Partial Discharge Detection and Location in Covered Conductor Overhead Distribution Networks

A Novel On-Line Differential Technique For Partial Discharge Measurement Of Mv/Hv Power Cables

A Cost-Effective Technique for PD Testing of MV Cables under Combined AC and Damped AC Voltage

Analysis of Partial Discharge Measured on Field for Cable Joint

A Novel Oscillation Wave Test System for Partial Discharge Detection in XLPE Cable Lines

An ACRF Technique for PD Detection of XLPE Cables Based on Equivalent Pulse Width Modulation and Time Domain Reflectometry Denoising

A Technique to Identify the Types of Partial Discharges

An Improved Design of Damped AC Test System for Partial Discharge Measurement in Distribution Power Cables

A Method to Improve the Efficiency of Onsite Damped AC Test of Medium-voltage Cables

Robust On-Line Partial Discharge Measurement of 35-Kv Cables in Wind Farms Via Dual Sensors

A novel calibration method for PD measurements in power cables and joints using capacitive couplers

Partial Discharge and Noise Separation in Combined Cable–ohls Based on Three‐phase Power Ratios

An Efficient Methodology of Simultaneous Three-Phase Withstand Voltage and Sensitive Partial Discharge Testing of Medium Voltage Power Cables

A Novel Partial Discharge Detection Method for Power Transformers on Site Adopting Its Component As Ultra-High Frequency Sensor

Detection and Identification Technologies of Wide Band Partial Discharge

On-line Calibration of Partial Discharge Monitoring for Power Cable by HFCT Method

On-Line Partial Discharge Localization of 10-Kv Covered Conductor Lines