Formation Mechanism and Effect on the Mechanical Properties of TiSi Phase for Ti-5Al-5Mo-5Cr-3Nb-2Zr Alloyed by Silicon
Shichen Sun,Hongze Fang,Yili Li,Xiaofu Zhang,Ruirun Chen,Jingjie Guo
DOI: https://doi.org/10.1016/j.jallcom.2022.168510
2022-01-01
SSRN Electronic Journal
Abstract:To investigate the formation mechanism and evaluate the silicide effect on the microstructure and me-chanical properties of Ti-5Al-5Mo-5Cr-3 Nb-2Zr-xSi (Ti-xSi, wt%, x = 0, 0.2, 0.4, 0.6, 0.8) alloys, they are melted via vacuum arc melting and observed by scanning electron microscope (SEM) and transmission electron microscopy (TEM). The results indicate that their microstructure comprises grain boundary alpha (alpha GB), secondary alpha (alpha s), primary alpha (alpha p), and residual beta phases when the Si content is less than 0.2 wt%. With an increase in the Si content from 0.4 to 0.8 wt%, the content of the TiSi phase precipitated in alpha GB phase increases. Moreover, its size increases from 40 nm to 0.8 mu m. The diffusion of Si atoms from their high concentration in the beta to the alpha phase of the supersaturated solid solution is hindered by the phase boundary, resulting in the precipitation of silicides. The high energy at the interface and the diffusion of Si accelerate this precipitation. The elongation and fracture toughness increase at 0-0.2 wt% Si and then decrease at 0.4-0.8 wt% Si, peaking at Ti-0.2Si (7.1% and 66.4 MPamiddotm1/2, respectively). The strength is improved owing to the Si solid solution strengthening, precipitation of Ti5Si3 and TiSi phases, and strengthening effect caused by the difference in crystal plane spacing between the TiSi and the alpha GB phases. A higher silicide content leads to a gradual transformation from an intergranular ductile fracture to intergranular brittle fracture.(c) 2022 Elsevier B.V. All rights reserved.