Abstract:The solidification behaviours and microstructural characteristics of both ZA27/SiCp composites and monolithic ZA27 alloy were studied by using differential scanning calorimetry, scanning electron microscopy, transmission electron microscopy, electron probe microanalysis, and X-ray diffraction, It was found that there were differences in the transformation temperature and volume fraction of the phases, although the solidification process was almost identical for the composite and the monolithic alloy. The incorporation of SiC particles in the ZA27 alloy led to slight refinement of primary grains and reduced volume fraction of eutectic-like phase. The SiC particles obstructed Zn diffusion in the residual melt during the formation of proeutectic beta phase, but promoted Zn diffusion from alpha (Al) to eta (Zn) phase during eutectoid transformation. During solidification, Cu was mainly segregated in the final solidification regions; Mg was present not only in the matrix but also on SiC particles; and oxide inclusions were mainly distributed around SiC particles, The matrix microstructure for both materials mainly consisted of primary cores of Al rich alpha + eta eutectoid; beta' phase resulting from the eutectoid transformation of the proeutectic beta phase; and Zn rich alpha + eta eutectoid resulting from the eutectoid transformation of the eutectic-like phase. The SiC particles were mainly distributed around the primary grains, Several new phases based on the Al-Zn-Mg-Cu system and interfacial reaction products, including Al21Fe3Si, Cu5Zn8, Mg6Cu3Al7, MgAl2O4, and amorphous oxide inclusions, were identified in the final solidification regions. The nucleation of both primary alpha phase and eutectic-like alpha + eta phase at the surface of SIC particles and their crystallographic orientation relationships were investigated theoretically and experimentally. No distinct crystallographic orientation relationship between the matrix and SiC has been identified, although the mismatch between (0001)(SiC) and (111)(alpha) was calculated to be as small as 7.6%.

TEM Investigation of Spherical Primary Si Particles in As‐Quenched Al60Si40 Ribbons

MICROSTRUCTURE OF AS-MELT SPUN Al-Cu-Mg-Fe-Ni ALLOY AND ITS VARIATION IN CONTINUOUS HEAT TREATMENT

Microstructure and phase components of the as-cast Cu-0.4%Cr-0.12%Zr-0.01%Si

The Effect of Solution Treatment on the Si Particles’ Morphology Evolution and the Thermal Conductivity and Tensile Properties of Sb-Modified Al-8Si-0.6Mg Alloys

Solidification and microstructure of ZA27/SiCp composite fabricated by mechanical-electromagnetic combination stirring process

Effect of Rapid Heating and Cooling Conditions on Microstructure Formation in Powder Bed Fusion of Al-Si Hypoeutectic Alloy: A Phase-Field Study

Gradient Microstructure and Multiple Mechanical Properties of AlSi9Cu Alloy Ribbon Produced by Melt Spinning

An investigation on the microstructural stability of rapidly solidified AlFeVSi alloy ribbon

Investigation of particles on the microstructure, texture and formability of Al–Mg-Si-Zn alloy for automotive body sheet

The Microstructure of As-Melt Spun Al–7%Si–0.3%Mg Alloy and Its Variation in Continuous Heat Treatment

Influences of different Zr/Sc ratios on microstructure and mechanical properties of Al-2Si alloy

Microstructure and Mechanical Behavior of Quaternary Eutectic α+θ+Q+Si Clusters in As-Cast Al-Mg-Si-Cu Alloys

Two Directional Microstructure and Effects of Nanoscale Dispersed Si Particles on Microhardness and Tensile Properties of AlSi7Mg Melt-Spun Alloy

Solidification microstructure manipulation mechanism of hypoeutectic and hypereutectic Al-Si alloys controlled by trace in-situ nano-Fe 2 B and nano-Fe 3 Si

Microstructure Evolution of Primary Si Phase in Hypereutectic Al-20Si Alloys Prepared by Centrifugal Casting under an Electromagnetic Field

Interface Investigations of Alumina and Aluminosilicate Short-Fiber-reinforced Aluminum-Alloy Composites

Microstructural Refinement of Al-Si Alloy Upon Ultrasonic Nanocrystalline Surface Modification Treatment

Formation of Spheroidal Microstructure in Semi-solid State of Al-4.8Si-2.8Cu-0.5Mg Aluminium Alloy

Segregation and Morphological Evolution of Si Phase during Electromagnetic Directional Solidification of Hypereutectic Al-Si Alloys

Unveiling the Fine Microstructure of Nanoscale Composite Particles Embedded in Brittle Si Phase in an Al-Si-Cu-Mg Alloy

Investigation on morphology of primary Mg2Si in Al-20wt.%Mg2Si composite with experiment and first-principle calculations