Abstract:The accurate critical resolved shear stress (CRSS) ratios of different slip systems and deformation history are vital for the texture simulation and controlling for Ti80 alloy pipe during Pilger cold rolling process. This study proposed a comprehensive framework for determining these parameters. A method to calculate the CRSS ratio based on the statistics of activated slip systems was proposed, which could effectively eliminate the error of activated slip systems proportion caused by microtexture. No twinning was observed in the deformation of Ti80 alloy, and the activated slip systems of {0002}<11 2‾ 0>, {101‾ 0}<112‾ 0>, {101‾ 1}<112‾ 0> and {112‾ 2}<112‾ 3> were observed through uniaxial in-situ tensile test combined with EBSD at room temperature. And the CRSS ratio of Ti80 alloy has been calculated approximately as τBasal: τPrism: τPyram: τPyram = 1:0.8:3.5:6. Based on visco-plastic self-consistent (VPSC) model and the calculated CRSS, the texture with shear strain and without shear strain was simulated respectively in the Pilger cold rolling process. Meanwhile, the mechanism of texture formation was analyzed. The texture component was [0001] ‖ TD, and [11-20]‖ AD when the traditional velocity gradient neglecting shear strain was adopted in simulation. However, the shear strain in ZR direction would cause the texture to rotate 30° around the [0001] axis. Compared with that only considering the velocity gradient in the normal strain direction, the rolling texture can be more accurately predicted when considering the history of velocity gradient in all directions.

Rolling Texture Simulation of Aluminium Sheets Based on the Mechanism of Intergranule Reaction Stresses

Texture Evolution of Polycrystalline Aluminum During Rolling Deformation Ii. Theoretical Simulation

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

Computer Simulation of Rolling Textures Evolution of Pure Aluminum with Initial Texture

Modeling Texture Evolution During Rolling Process of AZ31 Magnesium Alloy with Elasto-Plastic Self Consistent Model

A Review of Texture Evolution Mechanisms During Deformation by Rolling in Aluminum Alloys

Crystal Plasticity Modeling of Texture Evolution and Heterogeneity in Equal Channel Angular Pressing of Aluminum Single Crystal

Simulation of rolling texture of aluminum with lath model

Evolution of Micro-Textures Within Individual Grains in Rolled Polycrystal Aluminum

Interpretation of the strain state during cross-roll rolling of aluminum by means of texture analysis

Finite Element Simulation of Influences of Grain Interaction on Rolling Textures of Fcc Metals

Mechanical Behavior and Texture Evolution of Aluminum Alloys Subjected to Strain Path Changes: Experiments and Modeling

Texture and Texture Randomization of Rolling Mg Alloy Sheet

Effect of Rolling Paths and Pass Reductions on the Microstructure and Texture Evolutions of AZ31 Sheet with an Initial Asymmetrical Texture Distribution

Effect of rolling geometry on the mechanical properties, microstructure and recrystallization texture of Al-Mg-Si alloys

Texture Modeling of Accumulative Roll‐Bonding Processed Aluminum Single Crystal {1 2 3}<6 3 4> by Crystal Plasticity FE

Experiments and Crystal Plasticity Finite Element Simulations of Texture Development during Cold Rolling in a Ti-15V-3Cr-3Sn-3Al Alloy

Deformation Mechanism of Cold Ring Rolling in View of Texture Evolution Predicted by a Newly Proposed Polycrystal Plasticity Model

Taylor-Type Simulation of the Rolling Texture of Pure Aluminum Taking into Account the Initial Texture

Calculation of the CRSS Ratios of Ti80 Alloy and Its Application in Prediction of Texture in Pilger Cold Rolling

Crystallization In Aluminum Roll-Casting Processes Under Electromagnetic Disturbance And Texture Evolution Of Roll-Casting Strips