Abstract:A new way on the magnitude and position of direction change of shear deformation resulted from rolling geometry and friction described by two parameters of Rf and Rp changed with practical rolling conditions is established for analyzing rolling textures. It is found that {001} <110> shear texture is dependent on the parameters of Rf and Rp, and rolling neutral angle is at the middle point of rolling deformation zone, i.e. Rp = 0.5, which favors development of {001}<110> shear texture. The results show that the rolling textures simulated by taking into account of Rf and Rp changed with practical rolling conditions are in better agreement with the measured than that of Rp = 0.5 in rolled high purity Al. Introduction Rolling textures and deformation microstructures have been demonstrated to be changed with rolling geometry and friction on contact surfaces between rollers and sample in previous investigations [1, 2, 3], in which {001}<110> shear texture and micro-shear bands with Cube orientation were found in rolled high purity aluminum with heavier rolling friction. However, the presented ways on effect of rolling geometry and friction on rolling texture components were either simple or complex, and rolling neutral angle position was hypothesized to be at the middle point of rolling deformation zone (RDZ) in literatures [4, 5, 6]. In current investigation, shear deformation can conventionally be changed with practical rolling conditions including rolling geometry and friction, especially, the position of direction change of shear deformation, i.e., rolling neutral angle, is not hypothesized to be at the middle point of RDZ per pass. Development of rolling textures in high purity Al rolled up to different total engineering strains is studied by experiment and modeling. Application of practical conditions on rolling texture modeling Practical Rolling conditions. All that rolling conditions are constrained by three angles, α, β and γ, and a relationship of the three angles can be described as known as

Simulation of rolling texture of aluminum with lath model

Computer Simulation of Rolling Textures Evolution of Pure Aluminum with Initial Texture

Taylor-Type Simulation of the Rolling Texture of Pure Aluminum Taking into Account the Initial Texture

Texture Evolution of Polycrystalline Aluminum During Rolling Deformation Ii. Theoretical Simulation

Finite Element Simulation of Influences of Grain Interaction on Rolling Textures of Fcc Metals

Crystal Plasticity Modeling of Texture Evolution and Heterogeneity in Equal Channel Angular Pressing of Aluminum Single Crystal

Shear Texture Gradient in Aa6061 Aluminum Alloy Processed by Accumulative Roll Bonding with High Roll Roughness

Modeling Texture Evolution During Rolling Process of AZ31 Magnesium Alloy with Elasto-Plastic Self Consistent Model

Multi-scale Modelling of Evolving Plastic Anisotropy During Al-alloy Sheet Forming

Thermo-mechanical coupled simulation during rolling on aluminum alloys

Finite element simulation of stretch bending on aluminum alloy extrusions

A Two-Scale Texture Modelling of AA1050 Aluminum Alloy after Accumulative Roll-Bonding (ARB)

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

A Review of Texture Evolution Mechanisms During Deformation by Rolling in Aluminum Alloys

Texture Modeling of Accumulative Roll‐Bonding Processed Aluminum Single Crystal {1 2 3}<6 3 4> by Crystal Plasticity FE

Numerical simulation evolution of shear strain and crystallographic textures during snake rolling of Al-Mg-Si alloy plate

Effect of Direction Change of Shear Deformation on the Textures in Rolled High Purity Al

Surface roughness effects in aluminium rolling

Finite Element Modeling for Deep-Drawing of Aluminum Alloy Sheet 6014-T4 Using Anisotropic Yield and Non-Afr Models

Predicting the in-plane mechanical anisotropy of 7085 aluminum alloys through crystal plasticity simulations and machine learning

A crystal plasticity FEM study of through-thickness deformation and texture in a {112} <111> aluminium single crystal during accumulative roll-bonding