Abstract:In this study, the crystal plasticity finite element method was established by coupling the crystal plasticity and finite element method (FEM). The effect of rolling deformation and slip system of polycrystalline Al-Mg-Si aluminum alloy was investigated. The results showed that there was a pronounced heterogeneity in the stress and strain distribution of the material during cold rolling. The maximum strain and shear strain occurred at surface of the material. The smaller the grain size, the lower the strain concentration at the grain boundary. Meanwhile, a smaller strain difference existed between the grain interior and near the boundary. The rotation of grains leads to significant differences in deformation and rotation depending on their initial orientations during the rolling process. The slip system of (11-1)<-110> had a large effect on the plastic deformation, (111)<10-1> is second, and the effect of (1-11)<011> slip system on the plastic deformation is the smallest. After deformation, the grain orientation concentration was increased with deformation. Therefore, both the strength and volume fraction of texture were increased with the increase in rolling deformation. The experimental results of EBSD indicated that the large rolling reduction resulted in severe grain twisting, so the texture strength was increased. The simulation results were in close agreement with the experimental results. This study provides a theoretical basis for the rolling process, microstructure, and performance control of aluminum alloys.

Deformation Mechanism of Cold Ring Rolling in View of Texture Evolution Predicted by a Newly Proposed Polycrystal Plasticity Model

Crystal Plasticity Finite Element Modelling of BCC Deformation Texture in Cold Rolling

Effects of cold rolling on the tensile response of glassy polymers: Experiments and modeling

Modeling Texture Development During Cold Rolling of IF Steel by Crystal Plasticity Finite Element Method

Simulation of Cold Ring Rolling Based on Rate Dependent Crystal Plasticity

Crystal Plasticity Modeling of Texture Evolution and Heterogeneity in Equal Channel Angular Pressing of Aluminum Single Crystal

Theoretical Analysis of Texture Evolution in Cold Rolling Process of Single Crystal Aluminum

Influence of Cold Rolling Reduction on the Deformation Behaviour and Crystallographic Orientation Development

Modeling Texture Evolution During Rolling Process of AZ31 Magnesium Alloy with Elasto-Plastic Self Consistent Model

Crystal Plasticity-Based Assessment of Constitutive Laws for Microstructure and Rolling Texture Capture in Ferritic Stainless Steel During Cold Rolling

Crystal Plasticity Investigation of Friction Effect on Texture Evolution of Al Single Crystal During ECAP

Effect of Hardening Models on the Prediction of Deformation Textures for Polycrystalline

Texture Evolution of Polycrystalline Aluminum During Rolling Deformation Ii. Theoretical Simulation

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

Texture Modeling of Accumulative Roll‐Bonding Processed Aluminum Single Crystal {1 2 3}<6 3 4> by Crystal Plasticity FE

Experimental Investigation and Simulation of the Texture Evolution During Rolling Deformation of an Intermetallic Fe-28 At.% A1–2 At.% Cr Polycrystal at Elevated Temperatures

Prediction of texture evolution under varying deformation states through crystal plasticity finite element method

Modeling and Experiment of Deformation Texture Development for Pure Al by CPFEM with EBSD Data

Experiments and Crystal Plasticity Finite Element Simulations of Texture Development during Cold Rolling in a Ti-15V-3Cr-3Sn-3Al Alloy

Numerical Simulation of Inhomogeneous Deformation in Cold Ring Rolling

Numerical Simulation on Sheet Metal Forming with Rate-Independent Polycrystalline Plasticity Fem