Abstract:The mixed-lubrication is generated at the wafer-pad interface, and the wafer-pad interaction is very complex during CMP process. Therefore, it is very important to study and reveal the fluid lubrication behaviour and the wafer status during industrialized CMP process. In this study, the wafer status monitoring system is further developed for the integrated in-situ measurement system to monitor the wafer bending and the wafer orientation in addition with the fluid pressure during the dynamic polishing process. Using this in-situ measurement system, the fluid lubrication behaviour is studied for the CMP process of 12-inch wafer. The positive-dominated fluid pressure is observed, and the fluid pressure increases with the downforce. Furthermore, the wafer bending and the wafer orientation are studied using the in-situ measurement system. The results reveal that there exists a slightly convex wafer bending by the order of 10 micrometer and a positive pitch angle on the order of 10(exp -5)~10(exp -4) degree under uniform downforce, and the wafer bending and pitch angle increase almost linearly with the downforce. The effects of the downforce on the wafer bending and the pitch angle are accordant with that on the fluid pressure, which indicates that the wafer bending and the wafer orientation play important roles in the hydrodynamic lubrication of CMP. Keywords: Chemical mechanical polishing, Fluid lubrication, In-situ measurement, Fluid pressure, Wafer orientation, Wafer bending

Comparative Study of the Lubricating Behavior Between 12-In. Copper Disk and Wafer During Chemical Mechanical Polishing

Preliminary Study of Disc Hydrodynamic Polishing

Experimental Studies on Interfacial Fluid Lubrication and Wafer Status During Chemical Mechanical Polishing of 12-Inch Wafer

Effects of the Polishing Variables on the Wafer-Pad Interfacial Fluid Pressure in Chemical Mechanical Polishing of 12-Inch Wafer

Wafer bending/orientation characterization and their effects on fluid lubrication during chemical mechanical polishing

Chemical effects on the tribological behavior during copper chemical mechanical planarization

Effect of Zone Pressure on Wafer Bending and Fluid Lubrication Behavior During Multi-Zone Cmp Process

In Situ Measurement of Fluid Pressure at the Wafer-Pad Interface During Chemical Mechanical Polishing of 12-Inch Wafer

Characteristics in chemical-mechanical polishing of copper: comparison of polishing pads

Comparison of Polishing Pad Characteristics in Copper-interconnect Chemical Mechanical Polishing of 300 Mm Wafer

Analysis on Pad Effects in Chemical Mechanical Polishing

Wear phenomena in chemical mechanical polishing

Tribology Analysis of Chemical‐Mechanical Polishing

Chemical-Mechanical Polishing of NiP Alloy for Hard Disk Drive Substrates

Contact Stress Non-Uniformity of Wafer Surface for Multi-Zone Chemical Mechanical Polishing Process

Mechanical Model of Single Abrasive During Chemical Mechanical Polishing: Molecular Dynamics Simulation

Material removal mechanism of copper chemical mechanical polishing with different particle sizes based on quasi-continuum method

Polystyrene-Silica Composite Particles and Their Copper Chemical Mechanical Polishing Performances

Chemical Mechanical Polishing of Copper in Glycine-H2O2 System Slurry

Investigation for Material Removal Mechanism in Copper Chemical Mechanical Polishing with Quasi-Continuum Method

Wear behavior of copper material removal during fluid jet polishing: A comparative study between experiment and simulation