Flow maldistribution and heat transfer non-uniformity with an inlet baffle structure in regenerative cooling channels
Wendi Du,Chaoyang Liu,Yu Pan
DOI: https://doi.org/10.1016/j.applthermaleng.2024.124619
IF: 6.4
2024-10-20
Applied Thermal Engineering
Abstract:Regenerative cooling is one of the most promising schemes for providing thermal protection for scramjets. Under multiple cooling channels, flow maldistribution easily leads to overheating and structural failures. Considering the complicated thermal environment in scramjet combustors, this study focuses on the relationship between flow maldistribution and heat transfer non-uniformity to improve the thermal performance. After validating the flow and heat transfer distributions, three types of heat flux boundary conditions and seven geometric configurations are numerically investigated with n-decane as the coolant. The conventional Z-type parallel channels are modeled with severe flow maldistribution, with the highest mass flow rate being four times more than the lowest. Moreover, the non-uniform heat boundary condition causes the maximum temperature with (486.71 K) to significantly vary. To realize a uniform flow distribution, a baffle structure is introduced into the inlet manifold, where high-pressure zones exist near the ribs and flow redistribution occurs. The modified geometry model comprises five additional channels, resulting in a more uniform flow distribution, higher pressure drops, and smaller variation of the maximum temperature under three types of heat loads. Furthermore, the influence of location and quantity of additional channels is analyzed with five additional geometry models. The dominant effect of the geometric structure is revealed, and the influence of heat flux condition strengthens when the flow maldistribution intensifies. The pressure drop in the inlet header increases with decreasing flow area. Additionally, the matching degree of the real and reference flow distributions (MDRR) is defined, which exhibits a better correlation with the thermal performance than flow uniformity. The maximum temperature increases with the MDRR. Moreover, the mass flow rate distribution is not the sole determining factor. The flow field in the inlet manifold also plays a role, contributing to the complexity of the relationship.
energy & fuels,engineering, mechanical,thermodynamics,mechanics