Abstract:Heat transfer of the hydrocarbon fuel at a supercritical pressure is a key process in the aerospace engine cooling applications. A CFD model is applied in this paper to study flow dynamics and heat transfer of the aviation kerosene RP-3 in a horizontal square cooling channel under asymmetric heating and buoyancy effects at various supercritical pressures. The turbulent fluid flows are handled by the standard k–ε turbulence model with an enhanced wall treatment, and the strong thermophysical property variations are calculated using the extended corresponding state approaches and a four-component surrogate model of RP-3. The effects of secondary flows and heat flux redistribution induced by buoyancy on supercritical-pressure heat transfer are analyzed. Results indicate that drastic variations of the fuel density with temperature at a supercritical pressure of 3 MPa induce strong buoyancy effect on heat transfer. In the top heated case, secondary flows carry the relatively cold fluid to the side and opposite walls, thereby increasing their fin effectiveness in heat transfer. As the operating pressure increases from 3 to 5 MPa, the density variation of RP-3 is decreased, consequently leading to the weakened buoyancy effect. As the solid thermal conductivity increases from 20 to 100 W/(m-K), the surface heat flux redistribution is dictated by heat conduction in the channel walls, and therefore, the buoyancy effect is significantly reduced. Numerical results herein could help elucidate the heat transfer characteristics of RP-3 in practical engine cooling processes.

Effect of Channel Aspect Ratio on Chemical Recuperation Process in Advanced Aeroengines

Effect of Enhanced Heat Transfer Structures on the Chemical Recuperation Process of Advanced Aero-Engine

Thermal management of fuel in advanced aeroengine in view of chemical recuperation

Thermal Behavior Inside Scramjet Cooling Channels at Different Channel Aspect Ratios

Parametric Study on the Hydrocarbon Fuel Flow Rate Distribution and Cooling Effect in Non-Uniformly Heated Parallel Cooling Channels

Effect of Geometry Parameters on the Hydrocarbon Fuel Flow Rate Distribution in Pyrolysis Zone of SCRamjet Cooling Channels

Aspect Ratio Effects on the Noncracking and Cracking Heat Transfer in Microchannels

Experimental study on chemical recuperation process of endothermic hydrocarbon fuel

Thermodynamic Analysis for a Chemically Recuperated Scramjet

Asymmetric Heating and Buoyancy Effects on Heat Transfer of Hydrocarbon Fuel in a Horizontal Square Channel at Supercritical Pressures

Effect of aspect ratio on heat transfer and fluid flow in regenerative cooling channel of liquid rocket engine thrust chamber

Thermal behavior in the cracking reaction zone of scramjet cooling channels at different channel aspect ratios

Numerical Investigation of the Thermal-Mechanical Behaviors in the Regenerative Cooling Channel Considering Thermal Pyrolysis

Effect of Cooling Channel Geometry on Re-Cooled Cycle Performance for Hydrogen Fueled Scramjet

Parametric numerical analysis of regenerative cooling in hydrogen fueled scramjet engines

Numerical Study on Flow and Heat Transfer of Supercritical Hydrocarbon Fuel in Curved Cooling Channel

The influences of the header geometry on hydrocarbon fuel flow distribution in compact parallel channels

The Flow Rate Distribution of Hydrocarbon Fuel in Parallel Channels with Different Cross Section Shapes

Flow and Mass Transfer of Pyrolytic Aviation Kerosene in Curved Channel

Parametric Study on the Distribution of Flow Rate and Heat Sink Utilization in Cooling Channels of Advanced Aero-Engines

Experimental study on the thermodynamic characteristics of the high temperature hydrocarbon fuel in the cooling channel of the hypersonic vehicle