Abstract:Titanium metal and titanium alloys are among the most widely used materials in biomedical devices because of their relatively high corrosion resistance and good biocompatibility. It has been suggested that the physiochemical and dielectric properties of the surface native oxide play a crucial role in the biocompatibility. There is increasing evidence that titanium may be extensively released in vivo and, under certain conditions, accumulated in adjacent tissues or transported to distant organs. Therefore, it is necessary to synthesize thicker and denser TiO2 films on titanium to enhance its biomedical properties. In this paper, we discuss our fabrication technique utilizing dual plasma generated by metal vacuum arc and radio frequency. The films fabricated consist of rutile crystal, although the substrates are not heated. As the oxygen partial pressure is raised, the intensity of the (101) and (110) diffraction peaks increases, and that of the (002) diffraction peak decreases. The preferred orientation of the TiO2 film shifts from (002) to (110) as a result of the competition between the surface free energy and ion bombardment. At low oxygen pressure, the TiO2 grain growth is mainly affected by ion bombardment, whereas thermodynamic factors affect the film growth at higher oxygen partial pressure. When the oxygen partial pressure reaches 0.93×10−2 Pa, further increase in the oxygen flow rate does not change the film composition. The film is completely oxidized and only comprises the TiO2 phase. The microhardness of the TiO2 films increases with the oxygen partial pressure and reaches a maximum value of 19 GPa at 1.7×10−2 Pa.

Preparation and Properties of P-type Conducting Titanium Oxide Film

Investigation of microstructure evolution in Pt-doped TiO2 thin films deposited by rf magnetron sputtering

Influence of Different Substrates on MgTiO_3-CaTiO_3 Thin Films Prepared by RF Sputtering

Preparation and Properties of Titanium Oxide Thin Film by Midfrequency Alternative Reactive Magnetron Sputtering Technique

TiO2 films prepared by DC reactive magnetron sputtering at room temperature: Phase control and photocatalytic properties

A Study of Titanium Oxide Film Electrodes Prepared by Direct Thermal Oxidation Ⅰ. Preparation, Structure and Electrochemical Properties

Processing and Characterization of TiO2film Prepared on Glass Via Pulsed Laser Deposition

Influence of Substrate on Structural, Morphological and Optical Properties of TiO2 Thin Films Deposited by Reaction Magnetron Sputtering

The Influence of Substrate Temperature on the Electrical and Optical Properties of Titanium Oxide Thin Films Prepared by D.c. Reactive Magnetron Sputtering

STRUCTURE AND OPTICAL PROPERTIES OF HIGH-RATE LOW-TEMPERATURE GROWN TiO2 THIN FILMS BY REACTIVE MAGNETRON SPUTTERING

Research of TiO2 Thin Films Prepared by DC Magnetron Sputtering

Process Effects on Heat-Sensitive Properties of Sputtered Tiox Thin Film

Fabrication and Optical-Electrical Properties of P-Type Manganese-Doped Titanium Dioxide Nano-Films

Metallic Sputtering Growth of Crystalline Titanium Oxide Films on Unheated Glass Substrate Using Inductively Coupled Plasma Assisted Direct Current Magnetron Sputtering

Fabrication and Electrical Properties of Titanium Oxide by Thermally Oxidizing Titanium on Silicon

Tunable thermo-optical performance promoted by temperature selective sputtering of titanium oxide on MgO-ZrO2 coating

Structure and properties of biomedical TiO2 films synthesized by dual plasma deposition

Effect of Electrolyte Composition on Growth Mechanism and Structure of Ceramic Coatings on Pure Ti by Plasma Electrolytic Oxidation

Compositional and Structural Evolution of the Titanium Dioxide Formation by Thermal Oxidation

Growth Mechanism and Corrosion Behavior of Ceramic Coatings on CP-Ti Produced by Plasma Electrolytic Oxidation

Preparation and characterization of wear resistant TiO layer on Ti alloy