Abstract:An ultra-precision servo control system for MWEDM (micro wire electrical discharge machining) based on piezoelectric ceramic motor drivers was developed. The servo discharge detection adopts an average voltage detection method, utilizes statistical methods to analyze the measured data, then controls discharge gap and makes the process more stable. The servo feed system based on DSP microprocessors applies a PID controller with incomplete derivation to reduce overshoot to improve machining accuracy, and also adopts adaptive dead-zone inverse compensation to eliminate dead-zone caused by piezoelectric ceramic motions in low servo feed speed. The simulation results show that the methods proposed in this paper can make the system recover its linearity and converge the dead-zone parameters. It is proved that the method proposed is efficient in solving this problem. Cooperating with a micro energy pulse generator, this equipment’s machining accuracy is smaller than ±0.2 micron, and surface roughness Ra is less than 0.1 micron. Punch die and cavity die (micro gear die, module 100 micron, thickness 3.5 millimeter) have been machined independently in two die steel work-pieces. These pieces can mate very well to work, which shows that the servo control system satisfies the need of MWEDM for high precision micro fabrication.

Study on Key Technology for Intricate Micro Parts on MWEDM

Study on Machining Technology of Micro-WEDM

Experimental study of MWEDM technology

Study to Enhance the Precision of Micro-Edm

Research on the Key Technologies of Micro Electro Discharge Machining

Research on micro-EDM machine tool and its key technologies

MWEDM Equipment and Its Application

Research Status and Trends of Micro-WEDM

Study on the Preparation Process for High Accuracy Micro Machining by Wire Electrical Discharge Machining

Advancements of Micro-Edm

Study on the Servo Control System of MWEDM

Study on Micro WEDMProcessing of Micro Rotary Structures

Fabrication of Micro Parts with Micro-WEDM

Key Technologies Of Machine Tool For Micro Electro, Discharge Machining

Micro-EDM and Its Key Techniques

SEVERAL KEY TECHNOLOGIES OF MICROELECTRONIC DISCHARGE MACHINING

Gap status identification and control of wire electrochemical micromachining

Research on a Micro EDM Equipment and Its Application

State of the Art in Intelligent Adaptive Energy- Saving Pulse Power Technology of WEDM

A Micro Die Fabrication Method By Using Mwedm

Study on Microrotating Structure Using Microwire Electrical Discharge Machining