Abstract:Ag doping in (RE)Ba2Cu3O7-delta [(RE)BCO] bulk high-temperature superconductors has been recognized as an effective way to improve the mechanical and superconducting properties of REBCO bulk superconductors for practical applications such as high-temperature superconducting (HTS) Maglev. Ag2O nanoparticles doped YBCO samples with different doping amounts (x, x varies from 0 similar to 0.5 wt%) were fabricated by Top-Seeded Melt-Growth method (TSMG). The samples' steady-state thermal conductivity (lambda) and the magnetic levitation force (F-L) were measured by a testing platform under a similar condition to the HTS Maglev system. The effects of Ag2O doping on the lambda and F-L of single domain YBCO bulks have been systematically studied. The lambda of the c-axis and the ab-plane were calculated through the steady-state heat flow method. We observed that lambda increases distinctly when x >= 0.3 wt%. The doping amount of 0.3 wt% has been evidenced to be the optimal value, of which the lambda of the c-axis and ab-plane are approximately 52% and 48% higher than the undoped one respectively. According to the results of the F-L measurement, we found F-L will increase while the relaxation rate of the F-L will decrease by adding trace amounts of Ag2O nanoparticles in comparison to the undoped sample. This observation suggests that Ag-doping is an effective way to enhance thermal conductivity as well as the superconducting properties of YBCO superconductors for practical applications.

AG DOPING EFFECTS OF YBCO BY LOW FLUORINE MOD METHOD

Ag Doping Effects on Y0.5Gd0.5Ba2Cu3O7−δmultilayers Derived by Low-Fluorine Metalorganic Solution Deposition

Ag Doping Effects of GdBa2Cu3O7-δFilms by Low Fluorine MOD Method

Co-doping effects of Gd and Ag on YBCO films derived by metalorganic deposition

Influence of Ag Doping on Thermal Conductivity and Magnetic Levitation of Single Grain Ybco Superconductors for High-Temperature Superconducting Maglev

Fabrication and Analysis of Tri-layer YBaCu Thick Films by Low-Fluorine MOD Method

Fabrication and Analysis of Tri-layer YBa 2 Cu 3 O 7− δ Thick Films by Low-Fluorine MOD Method

Effects of Ag Doping on the Critical Current Density of YBa2Cu3O7−y

Property Improvement of 600-Nm-thick YBCO Superconducting Films Fabricated Using a Pb-Modified MOD Method

Fabrication And Analysis Of Tri-Layer Yba2cu3 O (7-Delta) Thick Films By Low-Fluorine Mod Method

DOPING EFFECTS IN YBa2Cu1-xCox(Cu1-yZny)2Oz SYSTEM

Effects of Zn Doping on Superconducting Properties of Melt Textured Y–Ba–Cu–O Bulk Superconductors

Improved Superconducting Performance of YBCO-Coated Conductors by Low Energy Density Argon Ion Etching

Artificial Control for Nucleation and Growth Rate of YBa2Cu3O7-δ Coated Conductors Prepared by Low Fluorine Chemical Solution Deposition

Surface Morphology and Profile Analysis for Five-Layer YBa 2 Cu 3 O 7− Δ Thick Films Prepared by Low-Fluorine Metallorganic Deposition

Thick $\Hbox{yba}_{2}\hbox{cu}_{3}\hbox{o}_{7-\Delta}$ Superconducting Films by Low-Fluorine Metallorganic Solution Deposition

Effect of Doping on Phase Formation in YBCO Composites

Effect of Zinc Doping on the Microstructure in YBCO

Improvement of Bi-Layered YBCO Superconducting Films by Using Ag and Au Interlayers

THE EPITAXIALLY GROWTH AND GD DOPING EFFECT OF YBa2Cu3O7-δ SUPERCONDUCTING THIN FILMS BY LOW-FLUORINE MOD METHOD

Influence of Annealing Time on 5-Layer YBa2Cu3O7-δ Thick Films by Low-Fluorine Metal-Organic Deposition