Abstract:Adhesives are essential materials in engineering and their strength directly affects the safety of structures. The curing and environmental deterioration are critical areas of focus in adhesive researches. However, conventional studies on adhesive curing emphasize only on the characteristics of the adhesive itself, while studies on deterioration of adhesive-bonded structure tend to concentrate on detecting disbonds. In this work, we proposed to monitor the curing process and thermal failure of adhesive-bonded-structures based on damping measurement using a quantitative electromechanical impedance (Q-EMI) method. The performances of two adhesives, i.e., epoxy and cyanoacrylate, were studied via bonding a piezoelectric transducer onto one end of an alumina bar and measuring the admittance spectrum of the transducer-adhesive-alumina system. Results show that the damping steadily decreases during the curing process and eventually stabilizes for both adhesive-bonded structures. A significantly higher curing rate is observed at 60°C compared to that at room temperature. At high temperatures, the damping will increase dramatically, or no peaks can be observed in the admittance spectrum, indicating adhesive failure. The results indicate that the epoxy adhesive can function normally at temperatures up to 120°C and can endure heating-cooling cycles up to 180°C, while the cyanoacrylate adhesive can function normally at 140°C but fails upon cooling. The proposed Q-EMI method is quite powerful in monitoring the performances of bonded structures.

IR Analysis of Curing and Decomposability of One Component Middle Temperature Curing Heat-Resistant Adhesive

Study on Heat-Resistant Property of Adhesive/carbon–carbon Composites Joints

Effect of Heat Treatment under Different Atmospheres on the Bonding Properties and Mechanism of Ceramiziable Heat-Resistant Adhesive

Combinatorial investigation of structure–properties relationships and microcosmic curing mechanism of dental adhesives functional monomers

ANALYSIS OF ELEMENTS CONTENT ON ADHESIVE JOINT SURFACE AND INTERFACE WITH ENERGY DISPERSIVE X-RAY SPECTROSCOPY

Curing Analysis of Transparent,abrasion-Resistant Organosilicone Coatings

Study on Humidity Aging Property of Adhesive/Carbon-Carbon Composites Joints

Monitoring of the curing process and thermal failure of Adhesive-Bonded Structures based on damping measurement using quantitative electromechanical impedance

Investigation of Curing Characterization of Acetylene-Terminated Polyisoimide Oligomer

Modeling of curing and post-curing kinetics for a thermoset adhesive

Characterization and properties of high-temperature resistant structure adhesive based on novel toughened bismaleimide resins

The Effect of Curing Behavior on the Adhesive Properties

Study on Organosilicon Modified Epoxy Resin Adhesive for Heat-resistance

Thermal curing mechanisms and cross-linking network structure of a novel silicon-containing arylacetylene resin with 2,7-diethynylnaphthalene unit

Studies on Phase Separation of Polyesterimide-Modified Epoxy Resin. Ii. Effect of Curing Temperature on Phase Separation and Adhesive Property

Study of the infrared spectral features of an epoxy curing mechanism.

Cured Behavior and Microscopic Configuration of Phenolic Resin Modified by Polyathylene-Vinyl Alcohol

Evaluation of the Cure Kinetics of Isocyanate Reactive Hot‐melt Adhesives with Differential Scanning Calorimetry

Development of Organosilicon Adhesive with Low Decomposition and High Temperature Resistance

Study in Curing Properties of Two-Component Solvent-Free Polyurethane Adhesive

A ceramizable adhesive with high temperature resistance at 1400°C: Bonding strength and bonding mechanism