Abstract:The hot disk transient plane source (TPS) method is a widely used standard technique (ISO 22007-2) for the characterization of thermal properties of materials, especially the thermal conductivity, k. Despite its well-established reliability for a wide variety of common materials, the hot disk TPS method is also known to suffer from a substantial systematic errors when applied to low-k thermal insulation materials. Here, we present a combined numerical and experimental study on the influence of the geometry of hot disk sensor on measured value of low-k materials. We demonstrate that the error is strongly affected by the finite thickness and thermal mass of the sensor's insulation layer was well as the corresponding increase of the effective heater size beyond the radius of the embedded metal heater itself. We also numerically investigate the dependence of the error on the sample thermal properties, confirming that the errors are worse in low-k samples. A simple correction function is also provided, which converts the apparent (erroneous) result from a standard hot disk TPS measurement to a more accurate value. A standard polyimide sensor was also optimized using both wet and dry etching to provide more accurate measurement directly. Experimentally corrected value of k for Airloy x56 aerogel and a commercial silica aerogel using the numerical correction factor derived based on the standard TPS sensor is in excellent agreement with the directly measured value from the TPS sensor using the optimized polyimide sensor. Both of these methods can reduce the errors to less than 4% as compared to around 40% error of overestimation from raw values measured with the pristine sensor. Such results show that both the numerical correction to a pristine senor or an optimized sensor are capable of providing highly accurate value of thermal conductivity for such materials.

Optimizing the dynamic measurement of thermal conductivity and error analysis

Research on Dynamic Artificial Thermocouple Method

The prediction of effective thermal conductivities perpendicular to the fibres of wood using a fractal model and an improved transient measurement technique

A high-precision method to measure thermal conductivity of solids using reversible heat flux

Eigensystem Realization Method For Temperature Field Measurement Analysis Of Precision Machine

Study on Optimal Layout of Temperature Measurement for Thermal Errors of Spindle in Machine Tools

The Error Analysis of a Steady-State Thermal Conductivity Measurement Method With Single Constant Temperature Region

Analysis and Improvement of the Hot Disk Transient Plane Source Method for Low Thermal Conductivity Materials

Measurement of the Thermal Transport Properties of Dielectric Thin Films Using the Micro-Raman Method

Position-independent Thermal Error Compensation and Evaluation Based on Linear Correlation Filtering Technology

Measurement Techniques for Thermal Conductivity and Interfacial Thermal Conductance of Bulk and Thin Film Materials

An improved steady-state method for measuring the thermal contact resistance and bulk thermal conductivity of thin-walled materials having a sub-millimeter thickness

Automatic Algorithm Applied for Calculating Thermal Conductivity by Transient Plane Source Method

Principle of Measuring Thermal Conductivity Based on Steady-state Method

A Real-Time Measurement Method of Temperature Fields and Thermal Errors in Machine Tools

Analysis and Removal the High Frequency Effects in the Measurements of Thermal Conductance Using the TW Technique

An iterative algorithm to improve infrared thermographic systems’ accuracy in temperature field measurement of aluminum alloys

A systematic study on linear thermal expansion coefficient of metals based on interferometric measurement with Fresnel bimirror

Analysis of errors in the evaluation of parallel transient hot wire measurements by means of line heat source fits

Analysis of radiation effect on thermal conductivity measurement of semi-transparent materials based on transient plane source method

REAL-TIME MEASUREMENT OF MACHINE TOOL TEMPERATURE FIELDS AND THEIR EFFECT ON MACHINING ERRORS