Abstract:The frequency bandwidth of photothermal technique for thermal conductivity depth profiling has been studied, which is based on an iterative numerical algorithm for inverse calculation of inhomogeneous thermal conductivity depth profiles of solid samples. This inversion algorithm should require a sufficient frequency bandwidth since the numerical experiments have demonstrated that systematic errors will occur in the inversion from insufficient data. According to the thermal wave propagation property, at low frequency range, the thermal wave can penetrate into deep region of the sample, but it will depress spatial resolution because of its long thermal wavelength. Nevertheless, lack of low frequency the detected information will cause the derivation of the depth profiling in the deep part. On the other hand, with high frequency, the thermal wave only can penetrate into shallow regions near the surface of the sample, although the spatial resolution will be intensified because of its short thermal wavelength. However, lack of high frequency information will induce the depth profiling derivation near the surface layer. Theoretical analyses have indicated that there is a high frequency fhigh, at which or over the amplitude of the surface temperature tends to be proportional inversely to square root of frequency f, but the phase tends to a constant 0.25π. Besides, there is a low frequency flow, at which or below the amplitude will tend to be inversely proportional to f and the phase will tend to a constant 0.5π under the heat-insulation boundary condition at the rear surface. With the frequency bandwidth (flow,fhigh) all the necessary information is essentially included for reconstructing the depth profiling. Practically, the numerical experiments have also demonstrated the frequency bandwidth can be less than (flow,fhigh) based on the investigated conditions, which will be described in detail in the paper.

Analysis and Removal the High Frequency Effects in the Measurements of Thermal Conductance Using the TW Technique

Time-Frequency Analysis for Microwave Reflectometry Data Processing in the Hl-2a Tokamak

Accurate Evaluation of Transmission Line Model at Higher Frequencies for Characterising Field-to-Wire Coupling of Coated Twisted-Wire Pair with a Grounded Conductor

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

A high-precision method to measure thermal conductivity of solids using reversible heat flux

Analysis of errors in the evaluation of parallel transient hot wire measurements by means of line heat source fits

Numerical Approach for the Theory of Harmonic Self-Heating Technique to Measure Thermophysical Properties of Suspended Thin Samples

Short Hot Wire Technique for Measuring Thermal Conductivity and Thermal Diffusivity of Various Materials

A novel technique for extraction of thermal conductivity in metallic thin films

Frequency Bandwidth Optimization Of Photothermal Technique For Thermal Conductivity Depth Profiling

A Real-Time Measurement Method of Temperature Fields and Thermal Errors in Machine Tools

Characterization of Thermal Transport in One-Dimensional Solid Materials

Synthetic Analysis Method of the Heat Dissipation Capability of Slow-Wave Structure for Helix TWT

A three-probe method for accurate nanoscale thermal transport measurements

A High-Precision Instrumentation of Measuring Thermal Contact Resistance Using Reversible Heat Flux

Near-field radiation analysis and thermal contact radius determination in the thermal conductivity measurement based on SThM open-loop system

The Boundary Induced Error on the Measurement of Thermal-Conductivity by Transient Hot-Wire Method

Analysis and Improvement of the Hot Disk Transient Plane Source Method for Low Thermal Conductivity Materials

Automatic Algorithm Applied for Calculating Thermal Conductivity by Transient Plane Source Method

Generalized “slope Method” of the 3ω Analysis to Measure the Thermal Conductivity and Heat Capacity of Solids: Frequency- Vs. Current-sweep

Measurement Techniques for Thermal Conductivity and Interfacial Thermal Conductance of Bulk and Thin Film Materials