Abstract:In this study, a new casing process named expendable pattern shell casting process with vacuum and low pressure (EPSC-VL) was introduced to produce complicated and thin-walled aluminum alloy castings. The gas flowrate is one of the most important process parameters for manufacturing castings during the EPSC-VL process. In the present work, the influence of gas flowrate on the filling ability and internal quality of A356 aluminum alloy castings fabricated by the EPSC-VL process were investigated. Moreover, the filling ability, internal quality, as well as mechanical properties of A356 aluminum alloy castings obtained by EPSC-VL and lost foam casting (LFC) processes were also compared. The results obtained suggested that the filling length increased with the increase of gas flowrate, and the filling length of the thick section was larger than that of the thin section under the same gas flowrate when the gas flowrate was less than 19 m(3)/h. Furthermore, the porosity of castings decreased with increasing gas flowrate, and the microstructure of castings became denser, and the internal quality of castings was obviously improved. The comparison experiments showed that the EPSC-VL process had superior filling ability, internal quality, and mechanical properties compared with the LFC process, and the surface quality of castings obtained by EPSC-VL process was also better than that of the LFC process. The casting practice of complicated and thin-walled A356 aluminum alloy intake manifold part also suggested that the EPSC-VL process had an obvious advantage for the fabrication of complicated and thin-walled aluminum alloy castings compared with the LFC process.

Influence of Process Factors on Mould-Filling Velocity of Evaporated Pattern Casting(EPC)

Mold filling velocity during investment casting

Influence of Process Parameters on Filling Ability of A356 Aluminium Alloy in Expendable Pattern Shell Casting with Vacuum and Low Pressure

Effective Factors on Forming Precision in Patternless Casting Manufacturing Technique

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Effects of Process Parameters on Internal Quality of Castings During Novel Casting

Effect of Vacuum Degree on Quality of Magnesium Alloy by Low-Pressure Expendable Pattern Casting

Influence of Gas Flowrate on Filling Ability and Internal Quality of A356 Aluminum Alloy Castings Fabricated Using the Expendable Pattern Shell Casting with Vacuum and Low Pressure

Study on Polymer Flow Profile in Micro Hot Embossing

Experimental Study on the Filling Process of the Lost Foam Casting Process of a Cast Iron Plate

A Method on Computer Prediction of Shrinkage Defect of Ductile Iron Casting by EPC Process

Effect of different processing parameters on interfacial heat-transfer behavior in high-pressure die-casting process

Effect of Depressurizing Speed on Mold Filling Behavior and Entrainment of Oxide Film in Vacuum Suction Casting of A356 Alloy

Optimization of Control Parameters in Micro Hot Embossing

Processing Parameters of LFC Shell Mold Casting Aluminum Alloy Castings with Vacuum and Low Pressure

Surface Quality Improvement of Castings by Expendable Pattern Shell Casting with Vacuum and Low Pressure

Influence of foam pattern density on the surface roughness of expendable pattern-shell compound casting

Three-Dimensional Simulation of EPS Evaporation Process for Lost Foam Casting

Study on the Influence of Injection Velocity on the Evolution of Hole Defects in Die-Cast Aluminum Alloy

Numerical Simulation of Mold Filling of Polymeric Materials with Friction Effect during Hot Embossing Process at Micro Scale

An influence modelling and analysis method of reducing carbon emissions for mould forming processes in patternless sand casting