Abstract:In this study, a new casing process named expendable pattern shell casting process with vacuum and low pressure (EPSC-VL) was introduced to produce complicated and thin-walled aluminum alloy castings. The gas flowrate is one of the most important process parameters for manufacturing castings during the EPSC-VL process. In the present work, the influence of gas flowrate on the filling ability and internal quality of A356 aluminum alloy castings fabricated by the EPSC-VL process were investigated. Moreover, the filling ability, internal quality, as well as mechanical properties of A356 aluminum alloy castings obtained by EPSC-VL and lost foam casting (LFC) processes were also compared. The results obtained suggested that the filling length increased with the increase of gas flowrate, and the filling length of the thick section was larger than that of the thin section under the same gas flowrate when the gas flowrate was less than 19 m(3)/h. Furthermore, the porosity of castings decreased with increasing gas flowrate, and the microstructure of castings became denser, and the internal quality of castings was obviously improved. The comparison experiments showed that the EPSC-VL process had superior filling ability, internal quality, and mechanical properties compared with the LFC process, and the surface quality of castings obtained by EPSC-VL process was also better than that of the LFC process. The casting practice of complicated and thin-walled A356 aluminum alloy intake manifold part also suggested that the EPSC-VL process had an obvious advantage for the fabrication of complicated and thin-walled aluminum alloy castings compared with the LFC process.

Influence of foam pattern density on the surface roughness of expendable pattern-shell compound casting

Surface Quality Improvement of Castings by Expendable Pattern Shell Casting with Vacuum and Low Pressure

Study on the surface roughness of ceramic shells and castings in the ceramic shell casting process based on expandable pattern

Factors affecting the microstructure of a fine ceramic foam

Effects of Process Parameters on Internal Quality of Castings During Novel Casting

Study of Affecting Factors on Porosity in Gel-Casting Foam

Influence of Process Parameters on Filling Ability of A356 Aluminium Alloy in Expendable Pattern Shell Casting with Vacuum and Low Pressure

Relation Between Rheological and Curing Behavior of Inorganic Foam Slurries in the Gel-Casting Process

Influences of Material Selection, Infill Ratio, and Layer Height in the 3D Printing Cavity Process on the Surface Roughness of Printed Patterns and Casted Products in Investment Casting

Influence of Gas Flowrate on Filling Ability and Internal Quality of A356 Aluminum Alloy Castings Fabricated Using the Expendable Pattern Shell Casting with Vacuum and Low Pressure

Porosity of aluminum alloy in lost foam casting process

Analysis of Formation Mechanism of Typical Defects in Aluminum (Magnesium) Alloys Castings by the Expendable Pattern Shell Casting with Vacuum and Low Pressure

Study on High-Strength Ceramic Shell of Expendable Pattern Casting

An Experimental Characterization of Thermophysical Properties of a Porous Ceramic Shell Used in the Investment Casting Process

Mass Transfer of Lost Foam Casting and Its Influence on the Casting Quality

A Novel Method Based on Ultrastable Foam and Improved Gelcasting for Fabricating Porous Mullite Ceramics with Thermal Insulation–mechanical Property Trade-off

An investigation of ceramic shell thickness uniformity and its impact on precision in turbine blade investment casting

Effective Factors on Forming Precision in Patternless Casting Manufacturing Technique

Strictly Managing Pattern-material to Prevent the Occurrence of the Ash Defects in Wax Pattern

Influence of Process Factors on Mould-Filling Velocity of Evaporated Pattern Casting(EPC)

Thermo-Mechanical Behavior Analysis of Pressure Infiltration Casting Process for Manufacturing Open-Cell Metal Foam