Abstract:In this study, a new casing process named expendable pattern shell casting process with vacuum and low pressure (EPSC-VL) was introduced to produce complicated and thin-walled aluminum alloy castings. The gas flowrate is one of the most important process parameters for manufacturing castings during the EPSC-VL process. In the present work, the influence of gas flowrate on the filling ability and internal quality of A356 aluminum alloy castings fabricated by the EPSC-VL process were investigated. Moreover, the filling ability, internal quality, as well as mechanical properties of A356 aluminum alloy castings obtained by EPSC-VL and lost foam casting (LFC) processes were also compared. The results obtained suggested that the filling length increased with the increase of gas flowrate, and the filling length of the thick section was larger than that of the thin section under the same gas flowrate when the gas flowrate was less than 19 m(3)/h. Furthermore, the porosity of castings decreased with increasing gas flowrate, and the microstructure of castings became denser, and the internal quality of castings was obviously improved. The comparison experiments showed that the EPSC-VL process had superior filling ability, internal quality, and mechanical properties compared with the LFC process, and the surface quality of castings obtained by EPSC-VL process was also better than that of the LFC process. The casting practice of complicated and thin-walled A356 aluminum alloy intake manifold part also suggested that the EPSC-VL process had an obvious advantage for the fabrication of complicated and thin-walled aluminum alloy castings compared with the LFC process.

Surface Quality Improvement of Castings by Expendable Pattern Shell Casting with Vacuum and Low Pressure

Influence of foam pattern density on the surface roughness of expendable pattern-shell compound casting

Study on the surface roughness of ceramic shells and castings in the ceramic shell casting process based on expandable pattern

Effects of Process Parameters on Internal Quality of Castings During Novel Casting

Analysis of Formation Mechanism of Typical Defects in Aluminum (Magnesium) Alloys Castings by the Expendable Pattern Shell Casting with Vacuum and Low Pressure

Influence of Process Parameters on Filling Ability of A356 Aluminium Alloy in Expendable Pattern Shell Casting with Vacuum and Low Pressure

An investigation of ceramic shell thickness uniformity and its impact on precision in turbine blade investment casting

Influence of Gas Flowrate on Filling Ability and Internal Quality of A356 Aluminum Alloy Castings Fabricated Using the Expendable Pattern Shell Casting with Vacuum and Low Pressure

Investigation of Microstructures and Mechanical Properties of A356 Aluminum Alloy Produced by Expendable Pattern Shell Casting Process with Vacuum and Low Pressure

Study on High-Strength Ceramic Shell of Expendable Pattern Casting

Study on Influence of Surface Coating During Cooling Slope Rheocasting Process

Development of Advanced Coatings and Surface-sand Preventing Metal Penetration in Large-size Steel Castings by Furan Resin Sand Process

Effective Factors on Forming Precision in Patternless Casting Manufacturing Technique

Effects of Hollow Sand Mold on the Microstructure and Mechanical Properties of a Low Pressure Aluminum Alloy Casting

Effect of Vacuum Degree on Quality of Magnesium Alloy by Low-Pressure Expendable Pattern Casting

Mass Transfer of Lost Foam Casting and Its Influence on the Casting Quality

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Effect of silica sol on performance and surface precision of alumina ceramic shell prepared by binder jetting

Processing Parameters of LFC Shell Mold Casting Aluminum Alloy Castings with Vacuum and Low Pressure

Optimization of Casting System Structure Based on Genetic Algorithm for A356 Casting Quality Prediction

Correlation of Microstructure with Mechanical Properties and Fracture Behavior of A356-T6 Aluminum Alloy Fabricated by Expendable Pattern Shell Casting with Vacuum and Low-Pressure, Gravity Casting and Lost Foam Casting