Abstract:High concentration coal water slurry (CWS) is a new type of coal based liquid fuel developed and applied to replace oil for direct use in industry since the mid-seventies. Industrial tests of coal water slurry combustion in the 20 tons per hour steam output and 60 tons per hour steam output oil fired boilers have been carried out since 1981 in China. Nowaday, a project of burning coal water slurry in the 230 T/H utility boiler in Baiyanghe power plant has been made and several of the retrofit works have been done. This is the first time in this country. The boiler was originally designed based on burning coal. Actually, it keeps on burning oil. It has a cross-section of high length-width ratio (the long-side and short-side are 10.1 m and 7.15 m respectively, the ratio is 1/1.3). Based on the demand of power plant authority and the particularity of boiler construction, the CWM burners must be arranged on two side walls which are shorter than the front and rear wall. As we know, the length-width ratio of cross-section in a tangential fired furnace is generally suggested to be no more than 1/1.25. However, the ratio of this furnace hasmore » already been 1/1.3. If calculating in terms of burner-located points on furnace walls, the length-width ratio is 1/2.13. This obviously contradicts with general suggestion. No furnace aerodynamic information about this arrangement can be found. This arrangement will cause easily the deflection and impingement of the airflow, and it is difficult to form a good airflow distribution. So the retrofitting and design of the burner on the old boiler are very important. For this purpose, the experimental researches in two cold model facilities were carried out carefully. The experimental projects reported in this paper include the aerodynamic characteristic of two shape burners.« less

Application Study of Horizontal Concentrated Burners in Anthracite-fired 670t/h Boiler

STUDY ON ELIMINATING FIRE-CARRYING IN PRIMARY AIR JET ORIFICE BY ADMIXING EXHAUST GAS

Experiment research of anthracite coal mixed burning in boiler

Impact of Coal Types and Pulverizing Methods on the Thermal Performance of Blending Coal-Fired Boilers and Their Operational Optimization

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

STUDY ON IMPROVEMENT OF BURNING BEHAVIOR FOR INDONESIAN COAL AND ITS APPLICATION ON 300 MW UNITS

Experimental research on the fire-carrying problems in primary air nozzle of 125 MW units

Application of the Primary Air Enriched Burner in a Solely Heshan-coal-fired Pulverized Coal Boiler

Combustion System Renovation of 125MW Unit for Enhancing Coal Suitability and the Influence on NOx Emission

Study and Actualization of Burning Bituminous Coal in Lean Coal-fired Boiler of the 300 MW Unit

Retrofit of Burners of 410 T/h Boiler for Conversion from Burning Bituminous to Burning Lean Coal

Performance of the Primary Air Concentrators on Anthracite Ignition and Combustion in a 600 MW Supercritical Arch-Fired Boiler

Retrofit of Boiler in Shenhuolv Power Plant for Conversion the Kind of Coal

Experimental study of sludge disposal in a large coal-fired power plant

The numerical simulation and experimental research of Low-NOx burner retrofittingon a 420 T/h utility boiler

97/03976 Researches on the aerodynamic characteristics of CWS tangentially arranged burners in utility boilers

Experimental study on combustion and NOx emission characteristics of Zhehun blended coal

Principle and Experimental Study of Oxygen-Enriched High Temperature Air Combustion Burner

Theoretical and In-situ Experimental Investigation on Reducing Slagging Damage for Swirl-opposed Fired PC Boiler with Non-designed Blending Coals

CONCENTRATED PRIMARY AIR ARRANGEMENT TO MAKE BITUMINITE BURNED BOILER SLAGGING - PREVENT AND LOW NOx RELEASE

Investigation on slagging and high-temperature corrosion prevention and control of a 1000 MW ultra supercritical double tangentially fired boiler