Abstract:For inspection of mechanical properties and integrity of critical components such as integrated circuits or composite materials by acoustic methodology, it is imperative to evaluate their acoustic reflection coefficients, which are in close correlation with the elastic properties, thickness, density, and attenuation and interface adhesion of these layered structures. An experimental method based on angular spectrum to evaluate the acoustic coefficient as a function of the incident angle, θ, and frequency, ω, is presented with high frequency time-resolved acoustic microscopy. In order to achieve a high spatial resolution for evaluation of thin plates with thicknesses about one or two wavelengths, a point focusing transducer with a nominal center frequency of 25 MHz is adopted. By measuring the V(z, t) data in pulse mode, the reflection coefficient, R(θ, ω), can be reconstructed from its two-dimensional spectrum. It brings simplicity to experimental setup and measurement procedure since only single translation of the transducer in the vertical direction is competent for incident angle and frequency acquisition. It overcomes the disadvantages of the conventional methods requiring the spectroscopy for frequency scanning and/or ultrasonic goniometer for angular scanning. Two substrates of aluminum and Plexiglas and four stainless plates with various thicknesses of 100 μm, 150 μm, 200 μm, and 250 μm were applied. The acoustic reflection coefficients are consistent with the corresponding theoretical calculations. It opened the way of non-destructive methodology to evaluate the elastic and geometrical properties of very thin multi-layers structures simultaneously.

High-Frequency Photoacoustic Measurements in Air

Photoacoustic Properties of Metal-Insulator-metal Nanostructures

Ion-Implantation Measurements With A Noncontact Nondestructive High-Frequency Photoacoustic Technique

Simultaneous Thickness, Velocity, Density, and Attenuation Measurement of a Thin Layer by Time-Resolved Acoustic Microscopy

Nondestructive Evaluation of Semiconductors by Photoacoustic Imaging with High-Frequency Air Transducer

Angular Measurement of Acoustic Reflection Coefficients by the Inversion of V(z, T) Data with High Frequency Time-Resolved Acoustic Microscopy

Sensitivity Enhanced Photoacoustic Imaging Using a High-Frequency PZT Transducer with an Integrated Front-End Amplifier.

Simultaneously Measuring Thickness, Density, Velocity and Attenuation of Thin Layers Using V(z,t) Data from Time-Resolved Acoustic Microscopy.

[Non-Contacting Photoacoustic Tomography in Biological Samples].

Photo-Acoustic Measurement of Thermal Conductivity of Thin Films and Bulk Materials

Probing the Spatial Impulse Response of Ultrahigh-Frequency Ultrasonic Transducers with Photoacoustic Waves

Sub-Nyquist sampling-based high-frequency photoacoustic computed tomography

A cost-efficient frequency-domain photoacoustic imaging system

Photoacoustic Mesoscopy with Lower Cost: Using Photothermal Tunable Fabry-Perot Interferometric Ultrasound Sensor

Experimental design and numerical investigation of a photoacoustic sensor for a low-power, continuous-wave, laser-based frequency-domain photoacoustic microscopy.

Tutorial on Photoacoustic Microscopy and Computed Tomography

A frequency-domain non-contact photoacoustic microscope based on an adaptive interferometer

Photoacoustic Tomography from Weak and Noisy Signals by Using a Pulse Decomposition Algorithm in the Time-Domain.

Noinvasive photoacoustic tomography in biological tissue with ultrasonic probe beam

Photoacoustic Tomography using a Michelson Interferometer with Quadrature Phase Detection

Low-artifact and Long Depth of Field Photoacoustic Microscopy Using a Gaussian-weighted Annular Array