Abstract:In this work, the use of the photoacoustic technique for probing thermophysical properties of multi-layered nanofilms is explored. In the photoacoustic measurement of nanofilms, the thermal diffusion length must match with the thickness of the thin film, and the modulating frequency of the incident light should be much higher than usual so that to enhance the thermal-mechanical coupling and the spatial waviness of photoacoustic signal in both photoacoustic cell and sample itself. The current photoacoustic technique cannot fulfill the requirement of measuring thermophysical properties of multi-layered nanofilms. In present study, we develop a general photoacoustic model which takes thermal, mechanical, and optical properties, the geometry of a multilayer film, as well as the thermal contact resistances between layers into consideration. The frequency of the photoacoustic effect is extended to the ultrasonic region. The possibility of taking advantage of the resonance in the photoacoustic cell to overcome the decrease of the photoacoustic signal with the frequency increase is also explored. It is suggested that at high frequencies, the photoacoustic signals are obtained close to the resonance peak, which also contains the information of material's properties. Resonance frequencies, sensitivity and the frequency range with the highest sensitivity for different types of materials are analyzed. As an example, calculations of the photoacoustic signals of nanofilms of SiO2 and Ni show that increasing the frequency can improve the precision and accuracy of the photoacoustic measurement, and the photoacoustic technique is promising for depth-profiling of thermophysical properties of multi-layered nanofilms. Copyright © 2007 by ASME.

Photo-Acoustic Measurement of Thermal Conductivity of Thin Films and Bulk Materials

Thermal Diffusivity Determination of Solids by Time-Domain Photoacoustic Piezoelectric Technique

Theory of photoacoustic characterization of thermophysical properties of multilayered nanofilms

Measurement Accuracy Analysis of Thermal Diffusivities Determined by the Photoacoustic Piezoelectric Technique

construction of thermal conductivity distribution of inhomogeneous solids:laser-hardened Al alloys studied by photoacoustic technique

Photoacoustic Thermorelaxation Microscopy for Thermal Diffusivity Measurement.

Thermal properties of the material studied by the photoacoustic piezoelectric technique

Heat Transfer at Solid–Gas Interfaces by Photoacoustics at Brillouin Frequencies

Thermal Conductivity of Thin Films: Measurements and Understanding

Thermal Diffusivity of Light-Emitting Material Determination by Photoacoustic Piezoelectric Technique

Thermal diffusivity measurements of solids by photoacoustic piezoelectric technique

Simultaneous Thickness, Velocity, Density, and Attenuation Measurement of a Thin Layer by Time-Resolved Acoustic Microscopy

Contactless Measurement Of Electrical Conductivity Of Si Wafers Independent Of Wafer Thickness

Thermal Conductivity Measurement from 30 to 750 K: the 3ω Method

A Novel Technique for the Measurement of the Acoustic Properties of a Thin Linear-Viscoelastic Layer Using a Planar Ultrasonic Transducer

High-Frequency Photoacoustic Measurements in Air

Raman Scattering Characterization of Transparent Thin Film for Thermal Conductivity Measurement

Across-plane Thermal Characterization of Films Based on Amplitude-Frequency Profile in Photothermal Technique

Thermal Diffusivity Mapping of Solids by Scanning Photoacoustic Piezoelectric Technique

Contactless Measurement of Thin Film Conductivity by A Microwave Compact Equipment

Relation Between Photoacoustic Signal And Sample Thickness