Abstract:The solidification microstructure of aluminum foams is evidently different from that of bulk aluminum alloys. Generally, a single α-Al grain runs through the entire thickness of a cell-wall, and the grain morphology is irregular. However, the formation mechanism of the special microstructure in aluminum foams is unclear now, and few studies focused on optimizing the microstructure. In this study, grain refinement of aluminum foams by increasing cooling rate and inoculation were carried out, and thermal analysis was used to measure and judge solidification of aluminum foams. Experimental results show that grain refinement can be achieved by the above two methods, and the latter is more effective. The nucleation undercooling of aluminum foams decreases with the increase of Al–5Ti–1B addition. Grains can be well refined even in thin cell walls after inoculation, and the grain morphology changes from irregular to equiaxed. Under the same conditions, α-Al grains of Al foams are smaller than those of the bulk Al alloy, either with or without inoculation. An anisometric growth model of α-Al grains in foamed aluminum melt restricted by surrounding bubbles is proposed. The model shows that: (1) the size of the inhibited nucleation zone (INZ) around growing grains decreases due to the high constitutional undercooling caused by solute enrichment in cell walls, thus grains in cell walls are smaller than those of bulk Al alloy; (2) under normal solidification conditions, the shape of the INZ is irregular. Grains in aluminum foams will replicate contours of cell walls or Plateau borders, presenting irregular shapes. Increasing cooling rates and/or inoculation can reduce the size of INZ and change its shape. The grain morphology will change from irregular to equiaxed under proper conditions.

Solidification of fluid saturated in open-cell metallic foams with graded morphologies

Solidification Analysis of Density-Graded Closed-Cell Metallic Foam under Constant Temperature Boundary Condition

Experimental Investigation on the Solidification Behavior of Phase Change Materials in Open-Cell Metal Foams

Experimental Study on Enhanced Ice Storage in Open-Cell Metal Foams

Solidification microstructure and grain refinement of closed-cell aluminum foams

The Role of Porous Metal Foam on the Unidirectional Solidification of Saturating Fluid for Cold Storage

Performance Evaluation on the Gradient Design of Pore Parameters for Metal Foam and Pin Fin-Metal Foam Hybrid Structure

Thermal Analysis of Cold Storage: the Role of Porous Metal Foam

Experimental Investigation on the Solidification Rate of Water in Open-Cell Metal Foam with Copper Fins

Solidification Structure and Sound Absorbability of A356 Alloy Foams

Numerical study of solid-liquid phase change in metallic foam

Solidification in a shell-and-tube thermal energy storage unit filled with longitude fins and metal foam: A numerical study

Thermal and Fluid Transport in Micro-Open-Cell Metal Foams: Effect of Node Size

Coupling Effect Of Porosity And Cell Size On The Deformation Behavior Of Al Alloy Foam Under Quasi-Static Compression

Modelling on Thermal Transport in Cellular Metal Foams

Experimental Study on Capillary Microflows in High Porosity Open-Cell Metal Foams

Pore-scale Investigation on Flow Boiling Heat Transfer Mechanisms in Gradient Open-Cell Metal Foams by LBM

Thermal Transport in High Porosity Cellular Metal Foams

Design and assessments on graded metal foam in heat storage tank: An experimental and numerical study

Numerical Simulation on Thermal Properties of Closed-Cell Metal Foams with Different Cell Size Distributions and Cell Shapes

Effect of the Solid Phase Diffusion on the Mechanical Properties of Open-Cell Fe-Ni Alloy Foams