Abstract:Metal foam can effectively improve the melting rate of latent heat thermal energy storage units (LHTESU). However, the existing metal foam structure can’t simultaneously solve the problem of non-uniform melting caused by natural convection and slow melting rate in horizontal shell-and-tube LHTESU. To this end, the structure with fins and graded metal foam is proposed to further enhance thermal performance. The porosity of the metal foam increases gradually from the inner tube to the outer shell to reduce thermal resistance and improve thermal conduction globally. The fins (the porosity is 0) are employed to further enhance local heat transfer and balance the difference of melting rate between upper and lower parts. The correctness of the current model is verified by the one-phase Stefan problem with explicit solutions and research results in previous literature. With consideration of natural convection, the enthalpy-porosity method is adopted to compare the melting behavior of LHTESU strengthened by uniform metal foam, graded metal foam, fins and uniform metal foam, and fins and graded metal foam. The results show that the existence of the fins improves the uniformity of the temperature field and significantly shortens the melting time. Based on the same amount of metal materials, the proposed structure obtains the best strengthening effect in the four different structures. Furthermore, the effects of different structural parameters (the fins angle, fins thickness, and porosity gradient) on the melting process are discussed. It can be found that there are optimal values for the three structural parameters. Compared with the graded metal foam structure, the new structure (the fins angle is 25°, the fins thickness is 3 mm and the porosity gradient is 2%) further reduces the total melting time by 27.23% and increases the thermal energy storage rate by 36.52%.

Design and assessments on graded metal foam in heat storage tank: An experimental and numerical study

Performance Evaluation and Analysis of a Vertical Heat Pipe Latent Thermal Energy Storage System with Fins-Copper Foam Combination

Optimization of adaptive metal foam arrangement in a heat storage tank

Numerical investigation on thermal performance of phase change materials embedded in functionally graded metal foam

Numerical study of solidification and melting behavior of the thermal energy storage system with non-uniform metal foam and active rotation

Experimental and Numerical Studies on Melting/solidification of PCM in a Horizontal Tank Filled with Graded Metal Foam

Numerical simulation on thermal behavior of partially filled metal foam composite phase change materials

Effect of the circumferential and radial graded metal foam on horizontal shell-and-tube latent heat thermal energy storage unit

Radially graded metal foams arrangement in heat storage device of photothermal utilization systems

Investigation of optimization methods for metal foam with two-dimensional porosity gradient in shell-and-tube latent heat storage

Effect of fin-metal foam structure on thermal energy storage: An experimental study

Metal foam reinforced phase change material energy storage device: A collaborative optimization strategy for porosity and container shape

Design and study of metal foam parameters on whole melting-solidification cycle in phase change heat storage system

Numerical investigation and optimal design of partially filled sectorial metal foam configuration in horizontal latent heat storage unit

Gradient design of pore parameters on the melting process in a thermal energy storage unit filled with open-cell metal foam

Numerical and optimization study on heat storage and release process of novel fin-metal foam composite structures under periodic heat source

Melting behavior of the latent heat thermal energy storage unit with fins and graded metal foam

Experimental study on the thermal response of a metal foam dual phase change unit thermal storage tank

Design and operating evaluation of a finned shell-and-tube thermal energy storage unit filled with metal foam

Numerical thermal performance assessment of phase change process in a PCM/foam-fins enclosure under various thermal conditions

Numerical investigation and optimization of the melting performance of latent heat thermal energy storage unit strengthened by graded metal foam and mechanical rotation