Abstract:Metal foam can effectively improve the melting rate of latent heat thermal energy storage units (LHTESU). However, the existing metal foam structure can’t simultaneously solve the problem of non-uniform melting caused by natural convection and slow melting rate in horizontal shell-and-tube LHTESU. To this end, the structure with fins and graded metal foam is proposed to further enhance thermal performance. The porosity of the metal foam increases gradually from the inner tube to the outer shell to reduce thermal resistance and improve thermal conduction globally. The fins (the porosity is 0) are employed to further enhance local heat transfer and balance the difference of melting rate between upper and lower parts. The correctness of the current model is verified by the one-phase Stefan problem with explicit solutions and research results in previous literature. With consideration of natural convection, the enthalpy-porosity method is adopted to compare the melting behavior of LHTESU strengthened by uniform metal foam, graded metal foam, fins and uniform metal foam, and fins and graded metal foam. The results show that the existence of the fins improves the uniformity of the temperature field and significantly shortens the melting time. Based on the same amount of metal materials, the proposed structure obtains the best strengthening effect in the four different structures. Furthermore, the effects of different structural parameters (the fins angle, fins thickness, and porosity gradient) on the melting process are discussed. It can be found that there are optimal values for the three structural parameters. Compared with the graded metal foam structure, the new structure (the fins angle is 25°, the fins thickness is 3 mm and the porosity gradient is 2%) further reduces the total melting time by 27.23% and increases the thermal energy storage rate by 36.52%.

Design and operating evaluation of a finned shell-and-tube thermal energy storage unit filled with metal foam

Comparative study on heat transfer enhancement of metal foam and fins in a shell-and-tube latent heat thermal energy storage unit

Role of Porous Metal Foam on the Heat Transfer Enhancement for a Thermal Energy Storage Tube

Melting Evaluation of a Thermal Energy Storage Unit with Partially Filled Metal Foam *

Experimental visualization on thermal energy storage enhancement through metal foam filled annuli

Enhanced power density during energy charging of a shell-and-tube thermal storage unit: Comparison between the inclusion of metal fins and foams

Evaluation of different melting performance enhancement structures in a shell-and-tube latent heat thermal energy storage system

Effect of fin-metal foam structure on thermal energy storage: An experimental study

Numerical Study on Thermal Energy Storage Tube Filled by Metal Foam with Gradient Porosities

Performance Evaluation and Analysis of a Vertical Heat Pipe Latent Thermal Energy Storage System with Fins-Copper Foam Combination

Experimental Study on Melting and Solidification Cycle of a Hybrid Pin Fin/metal Foam Energy Storage Tank

On the Performance of Melting Features in a Thermal Energy Storage Unit: Metal Foam Argumentation

Solidification in a shell-and-tube thermal energy storage unit filled with longitude fins and metal foam: A numerical study

Melting behavior of the latent heat thermal energy storage unit with fins and graded metal foam

Fin-Metal Foam Hybrid Structure for Enhancing Solid–Liquid Phase Change

Experimental study on the thermal response of a metal foam dual phase change unit thermal storage tank

Melting enhancement in a shell-and-tube latent heat storage unit with staggered fin-foam synergistic configuration

Numerical and optimization study on heat storage and release process of novel fin-metal foam composite structures under periodic heat source

Effect of Filling Height of Metal Foam on Improving Energy Storage for a Thermal Storage Tank

Evaluation and Optimization of the Thermal Storage Performance of a Triplex-Tube Thermal Energy Storage System with V-Shaped Fins

Experimental and Numerical Investigations on Tilt Filling Design of Metal Foam in a Heat Storage Tank