Abstract:In the paper, melting performance of a latent heat thermal energy storage (LHTES) unit with phase change materials (PCMs) locally enhanced by porous media was numerically investigated. The filling ratio of the porous inserts was fixed to a low degree to reduce the material cost The optimal configuration of the porous inserts was obtained after the discussion about the effects of porous geometry and porosity on the velocity and temperature distribution of melting process. To reveal the superiority of the optimized result, different cases were compared with the help of a new comprehensive criterion about the input-output performance. Then a generalization expression was fitted out with some dimensionless parameters for the rapid calculation of melting fraction of the optimized result in practical application. The results indicated that in the horizontal LHTES unit, the limited porous inserts should be concentrated in the bottom part without interval between the neighboring porous inserts, providing an effective enhancement in the lower part and a low degree of thermal stratification. If the mass of porous inserts is fixed, high porosity is preferred to make the thermal-conduction-dominated area sufficiently covered by the porous inserts. Compared with the non enhancement case, the selected result in this study can remarkably save more than 80% of the melting time and enhance the melting rate by 5.1 times. More significantly, the selected result has the highest melting rate per cost of the material when the price ratio of the addition to the PCM is larger than 5 based on the results of economic assessment Therefore, it offers an economical solution to the thermal enhancement problem of the LHTES unit in the practical application. The normalized equation of melting fraction is obtained for the parameter range of 0.187 < Ste < 0.374, 1.325 x 10(6) < Ra < 2.649 x 10(6): f = 0.596X + 0.0438X(2)-0.0825X(3) + 0.0130X(4), where X = SteFoRa(1/8) < 2.796.

Numerical investigation and optimization of the melting performance of latent heat thermal energy storage unit strengthened by graded metal foam and mechanical rotation

Synergistic Improvement of Melting Rate and Heat Storage Capacity by a Rotation-Based Method for Shell-and-tube Latent Thermal Energy Storage

Numerical study of solidification and melting behavior of the thermal energy storage system with non-uniform metal foam and active rotation

Parametric Study on Melting Process of a Shell-and-tube Latent Thermal Energy Storage under Fluctuating Thermal Conditions

Melting behavior of the latent heat thermal energy storage unit with fins and graded metal foam

Numerical investigation on thermal performance of phase change materials embedded in functionally graded metal foam

Investigation on latent heat energy storage using phase change material enhanced by gradient-porosity metal foam

Effect of the circumferential and radial graded metal foam on horizontal shell-and-tube latent heat thermal energy storage unit

Investigation of optimization methods for metal foam with two-dimensional porosity gradient in shell-and-tube latent heat storage

Experimental study on the effect of rotation on melting performance of shell-and-tube latent heat thermal energy storage unit

Effect of metal foam with two-dimensional porosity gradient on melting behavior in a rectangular cavity

Metal foam reinforced phase change material energy storage device: A collaborative optimization strategy for porosity and container shape

Optimization of adaptive metal foam arrangement in a heat storage tank

Gradient design of pore parameters on the melting process in a thermal energy storage unit filled with open-cell metal foam

Experimental and Numerical Studies on Melting/solidification of PCM in a Horizontal Tank Filled with Graded Metal Foam

Melting Performance Enhancement of Phase Change Material by a Limited Amount of Metal Foam: Configurational Optimization and Economic Assessment

Numerical investigation and optimal design of partially filled sectorial metal foam configuration in horizontal latent heat storage unit

Study on melting process of latent heat energy storage system by nano-enhanced phase change material under rotation condition

Enhancement of melting performance in a shell and tube thermal energy storage device under different structures and materials

A simplified phase change model and performance optimization of plate latent heat storage unit with graded porous

Design and assessments on graded metal foam in heat storage tank: An experimental and numerical study