Abstract:The combination of latent heat storage (LHS) technology with the Organic Rankine Cycle represents a widely recognized solar thermoelectric conversion means. However, this technology is hindered by the instability of solar energy and the poor thermal conductivity of thermal storage materials. This study addresses the challenges posed by solar energy fluctuations by implementing a sinusoidal heat source condition during the heat release process of LHS system. Furthermore, a comprehensive approach is taken to enhance heat transfer, incorporating both active methods such as rotational conditions, and passive methods using metal nanoparticles and high-performance fins. The Taguchi method is employed to optimize rotation speed, heat source amplitude, and half-period of the latent heat storage unit, and the resulting heat release performance is compared between different structures and the optimized structures. The findings from optimal design analysis reveal that rotation speed has the most significant influence on mean heat discharging rate and solidification time, followed by the heat source amplitude and half-cycle period. There is a notable interaction between heat source amplitude and half-cycle period. Compared to the initial structure, the optimal structure identified through the optimal design shortens the solidification time by 11.18%, increases the mean heat discharging rate by 13.04% and raises the average temperature response by 18.82%. Furthermore, the addition of Al 2 O 3 nanoparticles further enhances heat discharging properties. Specifically, the presence of 2.5% and 5% Al 2 O 3 nanoparticles shortens unit solidification time by 9.52% and 18.83% and increases the mean heat release rate by 7.69% and 17.26%. It is noted that the incorporation of rotating-fit nanoparticles partly compensates for the limitations of increased viscosity and particle settlement associated with metal nanoparticles, although it does not fully address the challenges related to reduced heat storage/release.

Experimental study on the effect of rotation on melting performance of shell-and-tube latent heat thermal energy storage unit

Synergistic Improvement of Melting Rate and Heat Storage Capacity by a Rotation-Based Method for Shell-and-tube Latent Thermal Energy Storage

Numerical Investigation of Heat Transfer Characteristics in a Shell- And-Tube Latent Heat Thermal Energy Storage System

Parametric Study on Melting Process of a Shell-and-tube Latent Thermal Energy Storage under Fluctuating Thermal Conditions

Effects of Fluctuating Thermal Sources on a Shell-and-tube Latent Thermal Energy Storage During Charging Process

Effects Evaluation of Fin Layouts on Charging Performance of Shell-and-tube LTES under Fluctuating Heat Sources

Numerical Analysis of Heat Transfer Behaviours of Melting Process for Ice Thermal Storage Based on Various Heat Source Configurations

Numerical investigation and optimization of the melting performance of latent heat thermal energy storage unit strengthened by graded metal foam and mechanical rotation

Numerical study of solidification and melting behavior of the thermal energy storage system with non-uniform metal foam and active rotation

Study of the melting performance of shell-and-tube latent heat thermal energy storage unit under the action of rotating finned tube

Investigation and optimization of solidification performance of a triplex-tube latent heat thermal energy storage system by rotational mechanism

Enhancing thermal performance in shell-and-tube latent heat thermal energy storage units: An experimental and numerical study of shell geometry effects

Exploring the impact of tube rotation on the melting performance of multi-tube latent heat storage systems: A numerical investigation

Study on melting process of latent heat energy storage system by nano-enhanced phase change material under rotation condition

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Design optimization on solidification performance of a rotating latent heat thermal energy storage system subject to fluctuating heat source

Simulation on paraffin melting enhancement in shell-tube phase change thermal storage equipment induced by natural convection

Effect of the circumferential and radial graded metal foam on horizontal shell-and-tube latent heat thermal energy storage unit

Evaluation and optimization of melting performance in a horizontal thermal energy storage unit with non-uniform fins

Influence of rotation on heat absorption performance of solid–liquid phase change tank

Development of multilayer interacted characteristic melting region for large-scale horizontal latent heat storage investigation