Abstract:Hypothesis: Zirconia microparticles produced by sol-gel synthesis have great potential for photonic applications. To this end, identifying synthetic methods that yield reproducible control over size uniformity is important. Phase transformations during thermal cycling can disintegrate the particles. Therefore, understanding the parameters driving these transformations is essential for enabling high-temperature applications. Particle morphology is expected to influence particle processability and stability. Yttria-doping should improve the thermal stability of the particles, as it does in bulk zirconia. Experiments: Zirconia and YSZ particles were synthesized by improved sol-gel approaches using fatty acid stabilizers. The particles were heated to 1500 °C, and structural and morphological changes were monitored by SEM, ex situ XRD and high-energy in situ XRD. Findings: Zirconia particles (0.4-4.3 μm in diameter, 5-10% standard deviation) synthesized according to the modified sol-gel approaches yielded significantly improved monodispersities. As-synthesized amorphous particles transformed to the tetragonal phase at ∼450 °C with a volume decrease of up to ∼75% and then to monoclinic after heating from ∼650 to 850 °C. Submicron particles disintegrated at ∼850 °C and microparticles at ∼1200 °C due to grain growth. In situ XRD revealed that the transition from the amorphous to tetragonal phase was accompanied by relief in microstrain and the transition from tetragonal to monoclinic was correlated with the tetragonal grain size. Early crystallization and smaller initial grain sizes, which depend on the precursors used for particle synthesis, coincided with higher stability. Yttria-doping reduced grain growth, stabilized the tetragonal phase, and significantly improved the thermal stability of the particles.

Fabrication of Super-Microporous Nanocrystalline Zirconia with High Thermal Stability

Synthesis of Monolithic Zirconia with Macroporous Bicontinuous Structure Via Epoxide-Driven Sol–gel Process Accompanied by Phase Separation

Fabrication of Submicron Tetragonal Polycrystalline ZrO2 by the Transformation of Micro Monoclinic ZrO2 under High Pressure

Hydrothermal Synthesis and Characterization of Zirconia Nanocrystallites

Synthesis and Characterization of Yttria-Doped Mesoporous Zirconia

Synthesis and Characterization of Doped Nano-Sized Ceria–zirconia Solid Solutions

Study on the process and properties of nano-sized polycrystal zirconia powders by co-precipitation in super-alkaline medium

Preparation and Characterization of Mesoporous Zirconia Materials by Self-Assembly Method

Optimization of the structure and morphology of monoclinic phase nanoscale zirconium dioxide

Preparation and Microstructure of Nanometer Tetragonal Polycrystal Zirconia Powder at Low Temperature Condition

PREPARATION AND PROPERTIES OF NANOMETER POLYCRYSTALS ZIRCONIA POWDER BYSUPER ALKALINE METHOD AT LOW TEMPERATURE WITH ORGANIC ADDITIVES

Preparation of macroporous zirconia monoliths from ionic precursors via an epoxide-mediated sol-gel process accompanied by phase separation

Study on a new, environmentally benign method and its feasibility of preparing nanometer zirconia powder

Synthesis and thermal stability of zirconia and yttria-stabilized zirconia microspheres

Synthesis and Pyrolysis Evolution of Glucose-Derived Hydrothermal Precursor for Nanosized Zirconium Carbide

Co-precipitation of nano Mg–Y/ZrO2 ternary oxide eutectic system: Effects of calcination temperature

Synthesis and Characterization of Thermally Stable Mesostructured Sulfated Zirconia by a Novel Sulfate-Assisted Alcohothermal Route

From modification to mechanism: Supercritical hydrothermal synthesis of nano-zirconia

Mechanochemical dehydration and crystallization of supersaturated zirconia–alumina composite nano powders

Sintering Behavior and Mechanical Properties of Alumina-Coated Zirconia Ceramics

Preparation of High Surface Area Zirconia by RefluxDigestion in Basic Solutions