Abstract:As the power density of the power transmission device increases, heat exchangers are required to dissipate more heat and provide better flow resistance in the limited space of the vehicle. In this study, the synergy mechanism of the temperature field, pressure field, and velocity field in the serrated fin channel of the plate-fin heat exchanger (PFHX) was thoroughly analyzed under the guidance of the three-field synergy principle. This study also quantitatively revealed the distribution of the angle θ between the temperature gradient and velocity, and the angle α between the pressure gradient and velocity. For the regions in the channel where θ was too large (i.e., poor synergy between temperature and velocity fields) and α was too small (i.e., poor synergy between pressure and velocity fields), high-efficiency and low-resistance fin structures were proposed. The performance improvement of the new structures was quantified using the comprehensive heat transfer and flow resistance performance evaluation plot in the three-field synergy standard. The results indicate that the new structures improve the synergy of the three fields in the channel. When the air velocity is 15 m s −1 , the average synergy angle θ m between the temperature gradient and the velocity of the two structures, changing the inlet flow direction and the slotted fin, decreases from 83.4° to 80.3° and 82.8°, respectively. The outlet temperature increases by 2.3 and 1.6 K, respectively, compared to the basic structure, indicating enhanced the heat transfer of the PFHX. By changing the shape of the fin cross-section, the average synergy angle α m between the pressure gradient and the velocity increased from 143.6° to 150.8°, while θ m increased by only 0.6°. The pressure loss was reduced by 15.2% compared to the basic structure, resulting in a significant decrease in pressure drop while maintaining essentially the same heat transfer performance. Meanwhile, the optimized PFHX can increase the heat transfer rate by 0.2%–8% under identical pump power. This work provides guidance on selecting high-efficiency and low-resistance vehicle-mounted PFHXs.

Application of Field Synergy Principle for Fin Reshaping of a Natural Convection Radiator

Thermohydraulic Performance Optimization of Integrated Porous Pin Fins in Microchannel Heat Sink Using Shape Optimization Coupled with NSGA

Field Synergy Analysis on Convective Heat Transfer and Fluid Flow of a Novel Triangular Perforated Fin

Enhancing Plate-Fin Heat Exchanger Hydraulic Thermal Performance Through Air-Side Fin Optimization Based on Pseudo-3D Topology Optimization

NUMERICAL DESIGN OF EFFICIENT SLOTTED FIN SURFACE BASED ON THE FIELD SYNERGY PRINCIPLE

Field Synergy Analysis of Heat Transfer Enhancement on Slit Wavy Fins

Numerical simulation and field synergy analysis of heat transfer performance of radial slit fin surface

A local synergy angle of velocity, temperature and pressure fields for enhancement of comprehensive heat transfer performance

Three-dimensional numerical study of heat transfer characteristics of plain plate fin-and-tube heat exchangers from view point of field synergy principle

Three-dimensional Numerical Study and Field Synergy Principle Analysis of Wavy Fin Heat Exchangers with Elliptic Tubes

Numerical analysis of magneto-radiated annular fin natural-convective heat transfer performance using advanced ternary nanofluid considering shape factors with heating source

A TPMS-Based Hybrid Fin Design for Effective Heat Transfer Enhancement

Application of response surface methodology and computational fluid dynamics for analyzing and optimizing the performance of finned solar air heater

A Unified Analysis on Enhancing Single Phase Convective Heat Transfer with Field Synergy Principle

Application of Combined Enhanced Techniques for Design of Highly Efficient Air Heat Transfer Surface

Numerical study and experimental verification of transverse direction type serrated fins and field synergy principle analysis

Exploration and numerical study of new structures for high-efficiency and low-resistance vehicle-mounted plate-fin heat exchanger based on the three-field synergy principle

Numerical Analysis on Heat Transfer Enhancement by Longitudinal Vortex Based on Field Synergy Principle

Experimental and Numerical Investigation of Natural Convection Heat Transfer of W-type Fin Arrays

Enhancement mechanism on heat and mass transfer of tall fin with cycloid thermosyphon loop

Numerical Investigation of Performance Enhancement for Thermoelectric Generator System Optimization of HX Fin Shape