Abstract:The ventilation systems in nuclear power plants, hydropower plants, and other large-scale projects involve the transportation of fluids through large-scale pipelines. To achieve a more stable flow velocity distribution, the fluid needs to pass through a straight pipe section of sufficient length upon entering the pipe. Typically, this straight pipe section should be at least 15 times the inner diameter of the pipe. However, for large-diameter irregular square pipes with a diameter exceeding 1m, where the curved section is short and there are no long straight pipe sections before and after it, the flow field inside the pipe becomes complex, requiring accurate measurement of the flow rate.In this regard, a numerical simulation analysis is conducted to address this challenge. A mean velocity evaluation method based on the coefficient of variation is proposed. This method identifies multiple points within the pipe that best represent the average flow velocity, determining the insertion depth of sensors and the weight coefficients of these multiple measuring points. A calculation formula is derived, utilizing the cross-sectional average velocity as a function with the velocity values at multiple points in the flow field as independent variables. To validate the accuracy of the proposed method, flow measurement experiments are performed on a wind tunnel test bench. The calculated values obtained from the derived formula through numerical analysis are compared with the experimental results. The relative error within the full range is found to be less than 0.54%, confirming the accuracy of the formula. The research findings present a novel measurement method for airflow in large-diameter irregular square pipes and offer valuable practical insights for engineering applications.

A REVOLVING ONE HOLE PROBE IN 2 D GAS FLOW FIELD

Theoretical Calibration and Experimental Test of Hemispherical Seven-Hole Probe Under 3-D Flow Field in Wind Tunnel

Research of test by three-hole pressure probe in large-separated zone

Design and Test of an Integrated Measurement System for Multi-Hole Probe Calibration and Vortex Measurement

Large-Scale Flow Measurements and Analysis for Radial Inlets of Industrial Centrifugal Compressors Based on Multi-hole Probe System

Turbulent Boundary Layer Testing Technique over a Solid Surface under Water

Measurement of Gas and Liquid Flowing Through Holeson the Compound Tray

Turbine Rotor Outlet Flow-Field Measuring with Four-Hole Pressure Probe

3-D Velocity Automatic Measuring System Using 7-holes Pitot Tube

Wind tunnel experimental calibration of hemispherical 7-hole probe pressure–velocity parametric equation

Investigation of Three-Dimension Flow in a Multi-Stage Compressor Stator

Measurement of Low Wind Velocity under Low Pressure by an Improved Hot-bulb Probe

A study of mass flow rate measurement based on the vortex shedding principle

Investigation of the Pressure Probe Properties As the Sensor in the Vortex Flowmeter

Experimental investigation on a 3-transduders swirlmeter

Measurement and Analysis of Three-dimensional Flows in the Volute of a Centrifugal Compressor with a Round Section

Experiment Research on Method of Measuring Flow Direction for the Back to Back Probe and its Calibration

New method for measuring the solid-phase flow rate in gas-solid two phase flow

Application of Static Pressure Measurement System in Wind Tunnel Test

Numerical Simulation Analysis and Experimental Verification of Air Flow Measurement in Large-Diameter S-shaped Pipe

MEASUREMENT OF 3-DIMENSION FLOWING VELOCITY OF FLUE GAS BY THE CROSS CORRELATION METHOD