Abstract:A new nondestructive pressure-measurement method that can avoid potential safety problems caused by applying traditional pressure-measurement methods in vessels is presented. This method utilizes ultrasonic Rayleigh waves and critically refracted longitudinal waves ( L CR waves). The change in pressure induces a change in the stresses in the vessel's wall. According to the acoustoelastic principle, variations in stress affect the wave velocity. Meanwhile, the velocity of ultrasonic waves can also be affected by the change in temperature. Considering the effect of the pressure and temperature of the vessel on both the wave velocity and propagation distance of the ultrasonic waves, the relationship between ultrasonic transit time delay and both the pressure and temperature change is established. Furthermore, a modified model of pressure measurement is deduced. With this model, a reference method for temperature compensation, without temperature measurement, is presented. The reference method utilizes Rayleigh waves and L CR waves. These two kinds of ultrasonic waves travel along the axial direction of the vessel's wall, bearing the same changes in pressure and temperature. The relationship between the reference transit time delay between two ultrasonic transducers and the pressure is established through theoretical analysis and calibration tests on an air vessel. To reduce the error caused by the unevenness of temperature distribution, which might occur in the vessel's and the transducer's material, a new kind of transducer is used in the experiment, which has two piezoelectric elements and can be used for the Rayleigh and L CR waves. A pair of such transducers is mounted along the axial direction of the air vessel. The penetration area of the Rayleigh wave is almost the same as that of the L CR wave with the use of the new transducers. Comparison tests between the new transducers and the custom-used transducers show that the new transducers have better repeatability. Finally, using the air vessel as a specimen, experimental results show that the reference method is effective and that the pressure values calculated using the reference method are close to the manometer-measured values.

Research of test by three-hole pressure probe in large-separated zone

Divisionally Analytical Reconstruction of the Magnetic Field Around an Electromagnetic Velocity Probe

Numerical Simulation for Vibration of Interferometric Probein Wet Steam Flow Field

Analytical Calculation of the Measuring Error of an Electromagnetic Velocity Probe Caused by a Side Channel Wall

Theoretical Calibration and Experimental Test of Hemispherical Seven-Hole Probe Under 3-D Flow Field in Wind Tunnel

Design and Test of an Integrated Measurement System for Multi-Hole Probe Calibration and Vortex Measurement

Wind tunnel experimental calibration of hemispherical 7-hole probe pressure–velocity parametric equation

Investigation of the Pressure Probe Properties As the Sensor in the Vortex Flowmeter

Using the zonal calibration algorithm with adaptive inner boundary to improve the measurement accuracy of five-hole probe

A Deep-Sea Large-Volume High-Pressure Simulation System—design, Analysis and Experimental Verification

Research and Development of A Test System for the Dynamic Performance Testing of Pneumatic Solenoid Valves

Turbine Rotor Outlet Flow-Field Measuring with Four-Hole Pressure Probe

Optimal Design of Hemispherical 7-Hole Probe Tip With Perpendicular Holes

A REVOLVING ONE HOLE PROBE IN 2 D GAS FLOW FIELD

Numerical Simulation and Experimental Research on Measurement Characteristics of Elbow Meter

Shock Wave Spectrum Forming around the Compound Five-Hole Probe and its Influence on Pneumatic Parameters Acquisition during Subsonic to Supersonic Flow

A New Nondestructive Technique for Measuring Pressure in Vessels by Surface Waves

Investigation into pressure distribution of spool value with notches

High Precision Pressure Control in Large Closed Water Volume

The Hydraulic System Design of High Pressure Servo-control Pulse Test Bed

Nondestructive Pressure Measurement in Vessels Using Rayleigh Waves and <formula> <tex>$l_{\rm CR}$</tex> </formula> Waves