Abstract:Metrological characterisation of static energy meters under realistic low power quality conditions is a basic requirement for proper grid control and fair energy billing. The paper reports about a new proposed methodology, where the meters are tested under conditions directly recorded at installation sites. The waveforms of voltages and currents are sampled using a portable instrument; they are reproduced in laboratory conditions with a phantom power generator, with a bandwidth covering up to the 40th harmonic. The recording site is a photovoltaic energy production facility, having a a nominal power of 50 kW, at the coupling section to the grid. These waveforms were then reproduced in the laboratory, and tested on different models of single- and three-phase commercial static energy meters; the models chosen represent both energy meters used by energy providers at the point of common-coupling, and also meters typically used for in-line monitoring by end users. The quantity of interest is the reading error of the measured energy, when tested with the conditions reproduced from the on-field measurements, in comparison with a reference meter. All tested energy meter models comply with the present international documentary standards, which require tests under low power quality conditions; nevertheless, there are models that show unacceptable errors (up to 25%) in the measurement of active energy when tested with the on-field recorded waveforms. This suggests that the standardised testing waveforms might, in some cases, be not fully representative of the actual conditions encountered in the field.

Performance Evaluation of Energy Meters under Nonlinear Loads

Wide Area Electric Load Modeling Based on Smart Meter

Electric Load Data Characterising and Forecasting Based on Trend Index and Auto-Encoders

Research on the Impact of Harmonics on Electric Energy Measurement

Study on Electric Energy Metering Program under the Impact of Distorted Waveform

Active Energy Meters Tested in Realistic Non-Sinusoidal Conditions Recorded on the Field and Reproduced in Laboratory

Large Banks of Negative Differential Resistance Nonlinear Loads: A Hidden Threat to Power System Quality

Simulation and performance comparison of typical electric energy metering algorithms

Research on intelligent analysis device for dynamic error of electric energy

A Method of Evaluating Operation of Electric Energy Meter

Experimental and numerical study of impact of voltage fluctuate, flicker and power factor wave electric generator to local distribution

Nonlinear Resistance Characteristics Experimental Research

Research on power metering method for nonlinear loads in power system based on improved S-transform

Application of a Standard Power Meter for Detection Source of Harmonic Pollution and Reducing Economic Losses at Power Grid

The Nonlinear Dynamics Characteristics Recognition of Power Load under Electricity Market

Evaluation And Replacement Of Smart Meters

Performance of varhour meters in the presence of harmonics

Develop a power quality measurement system integrated with HAN home energy management system

The Influence of Subsequent Harmonics of the Load Current on Errors of Electronic Energy Meters

Non-Invasive Electromagnetic Sensor for Residential Harmonic Distortion

Residential Electricity Consumption Behavior Analysis and Energy Management Based on NILM