Abstract:Metrological characterisation of static energy meters under realistic low power quality conditions is a basic requirement for proper grid control and fair energy billing. The paper reports about a new proposed methodology, where the meters are tested under conditions directly recorded at installation sites. The waveforms of voltages and currents are sampled using a portable instrument; they are reproduced in laboratory conditions with a phantom power generator, with a bandwidth covering up to the 40th harmonic. The recording site is a photovoltaic energy production facility, having a a nominal power of 50 kW, at the coupling section to the grid. These waveforms were then reproduced in the laboratory, and tested on different models of single- and three-phase commercial static energy meters; the models chosen represent both energy meters used by energy providers at the point of common-coupling, and also meters typically used for in-line monitoring by end users. The quantity of interest is the reading error of the measured energy, when tested with the conditions reproduced from the on-field measurements, in comparison with a reference meter. All tested energy meter models comply with the present international documentary standards, which require tests under low power quality conditions; nevertheless, there are models that show unacceptable errors (up to 25%) in the measurement of active energy when tested with the on-field recorded waveforms. This suggests that the standardised testing waveforms might, in some cases, be not fully representative of the actual conditions encountered in the field.

Study on Electric Energy Metering Program under the Impact of Distorted Waveform

Wide Area Electric Load Modeling Based on Smart Meter

Simulation and performance comparison of typical electric energy metering algorithms

Research of Metering Scheme Key Techniques for Medium and Low Voltage DC Distribution Network

Research on intelligent analysis device for dynamic error of electric energy

Analysis of factors influencing electric energy measurement in power systems

A review on dynamic energy metering algorithms

The Influence of Subsequent Harmonics of the Load Current on Errors of Electronic Energy Meters

Research on power metering method for nonlinear loads in power system based on improved S-transform

Research on non-synchronous sampling errors in electric power system

Active Energy Meters Tested in Realistic Non-Sinusoidal Conditions Recorded on the Field and Reproduced in Laboratory

Research on Impact Load Measurement Method and Algorithm

Experimental and numerical study of impact of voltage fluctuate, flicker and power factor wave electric generator to local distribution

Study on Asynchronous Sampling in Digital Electrical Energy Metering Based on IEC61850

Design of a New Three-Phase Dynamic Harmonic Electric Energy Meter

ANALYZING, ESTIMATING AND SUPPRESSING THE INFLUENCE OF TRANSIENT ENERGY IMPULSE ON SYNCHRONOUS MEASUREMENT

Research on IEC61850 Based Verification Technologies of Digital Watt-hour Meter

An Approach for Electric Energy Data Processing Based on Metering Code

Optimal Meter Placement for Distribution Network State Estimation: A Circuit Representation Based Milp Approach

Measurement error analysis and accuracy improvement method based on gateway meter

Design and Simulation of Smart Prepaid-Postpaid Energy Meter with Alarm and Theft Control