Abstract:Metrological characterisation of static energy meters under realistic low power quality conditions is a basic requirement for proper grid control and fair energy billing. The paper reports about a new proposed methodology, where the meters are tested under conditions directly recorded at installation sites. The waveforms of voltages and currents are sampled using a portable instrument; they are reproduced in laboratory conditions with a phantom power generator, with a bandwidth covering up to the 40th harmonic. The recording site is a photovoltaic energy production facility, having a a nominal power of 50 kW, at the coupling section to the grid. These waveforms were then reproduced in the laboratory, and tested on different models of single- and three-phase commercial static energy meters; the models chosen represent both energy meters used by energy providers at the point of common-coupling, and also meters typically used for in-line monitoring by end users. The quantity of interest is the reading error of the measured energy, when tested with the conditions reproduced from the on-field measurements, in comparison with a reference meter. All tested energy meter models comply with the present international documentary standards, which require tests under low power quality conditions; nevertheless, there are models that show unacceptable errors (up to 25%) in the measurement of active energy when tested with the on-field recorded waveforms. This suggests that the standardised testing waveforms might, in some cases, be not fully representative of the actual conditions encountered in the field.

Simulation and performance comparison of typical electric energy metering algorithms

Study on Mathematics Model and Simulation for Feed Power System Non-Three Phase Running

A review on dynamic energy metering algorithms

Fast Quasi-Synchronous Harmonic Algorithm for IEC61850 Based Digital Energy Metering Devices

Four Harmonic Analysis and Energy Metering Algorithms Based on a New Cosine Window Function

Study on Electric Energy Metering Program under the Impact of Distorted Waveform

Monitoring Massive Appliances by a Minimal Number of Smart Meters

Research on non-synchronous sampling errors in electric power system

Fast Quasi-Synchronous Harmonic Algorithm Based on Weight Window Function — Mixed Radix FFT

A new algorithm for electric energy measurement based on four-order Hanning self-multiplication window triple-spectrum-line interpolation FFT

Design of a New Three-Phase Dynamic Harmonic Electric Energy Meter

New active electric energy measurement algorithm undernon-integer-period sampling

A new algorithm for electric energy measurement based on Hanning self multiplication-convolution window triple-spectrum-line interpolation FFT

Study on Asynchronous Sampling in Digital Electrical Energy Metering Based on IEC61850

An Approach for Electric Energy Data Processing Based on Metering Code

Research of Metering Scheme Key Techniques for Medium and Low Voltage DC Distribution Network

Research on power metering method for nonlinear loads in power system based on improved S-transform

Comprehensive Quality Assessment Algorithm for Smart Meters

Comparison of Detection and Suppression Methods for Voltage Fluctuation and Flicker

Research on intelligent analysis device for dynamic error of electric energy

Active Energy Meters Tested in Realistic Non-Sinusoidal Conditions Recorded on the Field and Reproduced in Laboratory