Abstract:Metrological characterisation of static energy meters under realistic low power quality conditions is a basic requirement for proper grid control and fair energy billing. The paper reports about a new proposed methodology, where the meters are tested under conditions directly recorded at installation sites. The waveforms of voltages and currents are sampled using a portable instrument; they are reproduced in laboratory conditions with a phantom power generator, with a bandwidth covering up to the 40th harmonic. The recording site is a photovoltaic energy production facility, having a a nominal power of 50 kW, at the coupling section to the grid. These waveforms were then reproduced in the laboratory, and tested on different models of single- and three-phase commercial static energy meters; the models chosen represent both energy meters used by energy providers at the point of common-coupling, and also meters typically used for in-line monitoring by end users. The quantity of interest is the reading error of the measured energy, when tested with the conditions reproduced from the on-field measurements, in comparison with a reference meter. All tested energy meter models comply with the present international documentary standards, which require tests under low power quality conditions; nevertheless, there are models that show unacceptable errors (up to 25%) in the measurement of active energy when tested with the on-field recorded waveforms. This suggests that the standardised testing waveforms might, in some cases, be not fully representative of the actual conditions encountered in the field.

Study on Asynchronous Sampling in Digital Electrical Energy Metering Based on IEC61850

Research on non-synchronous sampling errors in electric power system

Fast Quasi-Synchronous Harmonic Algorithm for IEC61850 Based Digital Energy Metering Devices

Electric Energy Measurement In Digital Substation On A Number Of Issues Discussed

Simulation and performance comparison of typical electric energy metering algorithms

Research on IEC61850 Based Verification Technologies of Digital Watt-hour Meter

Study on the Approachs of Electrical Harmonic Analysis for Asynchronous Sampling

Study on Electric Energy Metering Program under the Impact of Distorted Waveform

Research of Metering Scheme Key Techniques for Medium and Low Voltage DC Distribution Network

New Type of Digital Standard Electric Energy Meter Based on IEC61850 Communication Protocol

ANALYZING, ESTIMATING AND SUPPRESSING THE INFLUENCE OF TRANSIENT ENERGY IMPULSE ON SYNCHRONOUS MEASUREMENT

A review on dynamic energy metering algorithms

Comparison of Detection and Suppression Methods for Voltage Fluctuation and Flicker

Research on the fault diagnosis method of AC power supply in substations based on a synchronous digital sampling technology

Research and application of digital substation power quality monitoring system with high sampling rate

Research on intelligent analysis device for dynamic error of electric energy

Energy Theft Detection Via Integrated Distribution State Estimation Based On Ami And Scada Measurements

Asynchronous harmonic analysis based on out-of-sequence measurement for large-scale residential power network

An Approach for Electric Energy Data Processing Based on Metering Code

Active Energy Meters Tested in Realistic Non-Sinusoidal Conditions Recorded on the Field and Reproduced in Laboratory

Remote on-line calibration method and its technical realization for gateway energy meters