Abstract:We propose a scalable system of compact, superconducting neutron monitors, which can be embedded in any existing cryogenic infrastructure of a fusion system. The pixel-based nature of the detectors allows them to be placed at intervals following the circumference of a cooled zone, e.g., a field coil, thus allowing for a tomographic measurement of the neutron flux surrounding the plasma. An early stage prototype of the superconducting bolometer is described, and the key results of a previous feasibility study of this prototype performed with cold neutrons are summarized. The bolometer can be adapted for use with fast neutrons by altering the composition and geometry of the neutron-to-heat conversion layer. This paper describes the initial feasibility considerations for implementation in a superconducting tokamak. The sensor is based on a high-temperature superconductor, making it possible to select the operation temperature in the range 1-90 K. Neutron flux numbers were found using the ITER MCNP reference model, and these were embedded in a TOPAS model to find the expected signal measured by the bolometer at the position of a toroidal field coil. The results at the coil position indicate suitable operation levels in terms of the magnitude of the measured signal, with a measurable signal of several ohm, which is much smaller than the saturation energy of the detector. Radiation hardness is estimated and found to be on the order of at least 40 years for the relevant radiation levels. The upcoming investigation activities of the project are described for both radiation testing and analytical modeling.

Operation of Bolometer System Using Pt Foil on SiN Substrate Detector for EAST Tokamak.

Microwave Diagnostics System in the HL-2A Tokamak

Development of the Millimeter Wave Diagnostics on HL-2A

Wide-Range Bolometer with RF Readout TES

Design of A Magnetic Shielding System for the Time of Flight Enhanced Diagnostics Neutron Spectrometer at Experimental Advanced Superconducting Tokamak

Infrared Imaging Bolometer for the Hl-2a Tokamak

Design and Fabrication of Superconducting Transition Edge Sensor Bolometers with Background Limited Noise Performance

Microwave Doppler Reflectometer System in the Experimental Advanced Superconducting Tokamak.

The Performance of Superconducting NbN Hot Electron Bolometer with Nb5N6 Buffer Layer

Design and characterization of a 90 GHz CMB TES bolometer

The Performance of Suspended Superconducting NbN Hot Electron Bolometer with Buffer Layer

Superconductor based, tomographic, neutron diagnostics for fusion power monitoring

High Power Microwave Test System and Simulated Experiments for HT-7

A 0.6 THz quasi-optical detector based on a room microbolometer

Effects of Stoichiometric Ratio of NbN Films on the Performance of Hot Electron Bolometer Direct Detection

Edge Multi-Energy Soft X-Ray Diagnostic in Experimental Advanced Superconducting Tokamak.

Diagnostic Development for Parallel Wave-Number Measurement of Lower Hybrid Waves in EAST

Modelling of Freestanding Membrane-Supported Superconducting Al/Ti Bilayer Transition Edge Sensor Bolometer

Direct Detection Behavior of A Superconducting Hot Electron Bolometer Measured by Fourier Transform Spectrometer

Status of Neutron Diagnostics on the Experimental Advanced Superconducting Tokamak

Modular Bolometric/soft X-Ray Diagnostic in Sino-UNIted Spherical Tokamak.