Abstract:The evaporation of aviation kerosene droplets in the aeroengine combustion chamber is one of the basic processes during liquid fuel combustion, which directly affects fuel atomization, air-fuel mixture formation and the combustion quality. However, the data are rarely reported due to the difficulty of conducting experiments in high temperature and pressure conditions. In this study, a series of experiments were carried out to investigate the evaporation characteristics of RP-3 aviation kerosene droplet. The environmental pressure and temperature of droplet evaporation ranged from 1 and 20 bar and 400 and 600 °C respectively. An individual RP-3 kerosene droplet with initial diameter between 0.9 and 1.1 mm was suspended at a thermocouple bead with 50 μm diameter to measure droplet temperature. Droplet diameter during the whole evaporation process was recorded simultaneously by a high-speed camera. Experimental results indicated that at lower evaporation rate, RP-3 kerosene droplet evaporation experienced two processes: transient heating and equilibrium evaporation periods. While under high evaporation rates, the droplet only underwent equilibrium evaporation period without droplet expansion. At all the studied temperatures, droplet temperature kept increasing during the entire evaporation process without reaching a stable temperature. In most cases, the transient evaporation rate ( K ) of RP-3 kerosene droplet first increased rapidly until reaching the peak, and then followed by a monotonous decrease. However, at 20 bar above 500 °C conditions, the temporal K curve exhibited a double-peak feature. Above the critical temperature of the fuel, increasing ambient pressure and temperature both can promote the heating and evaporation. However, the promotion of increasing ambient temperature to droplet evaporation was weakened at high ambient pressure. The quantitative correlations of droplet lifetime and evaporation rate constant with pressure were proposed under different ambient temperatures.

Viscosity Measurement of Aviation Kerosene RP-3 Using a Double-Capillary Viscometer with Equal Mass Flow

Investigation of Oil-Air Two-Phase Mass Flow Rate Measurement Using Venturi and Void Fraction Sensor

Development of a Viscosity Measuring Device for Low Boiling Point Refrigerant Mixtures

A New Method for Liquid Viscosity Measurements: Inclined-Tube Viscometry

Development of Viscosity Real-time Measurement System Based on Capillary Method

Analyses of Surrogate Models for Calculating Thermophysical Properties of Aviation Kerosene RP-3 at Supercritical Pressures

Asymmetric Heating and Buoyancy Effects on Heat Transfer of Hydrocarbon Fuel in a Horizontal Square Channel at Supercritical Pressures

Oil-water two-phase flow measurement based on differential pressure

Experimental investigation on evaporation characteristics of RP-3 aviation kerosene droplet above the critical temperature under various pressure conditions

A two-capillary viscometer for temperatures up to 473 K and pressures up to 100 MPa – operation and verification at low pressure

Viscosity Measurements of the H-2-CO2, H-2-CO2-CH4, and H-2-H2O Mixtures and the H-2-CO2-CH4-CO-H2O System at 280-924 K and 0.7-33.1 MPa with a Capillary Apparatus

Experimental Studies on the Measurement of Oil-water Two-phase Flow

Heat Transfer Performance of Aviation Kerosene RP-3 Flowing in a Vertical Helical Tube at Supercritical Pressure

Buoyancy Effects on Supercritical-Pressure Conjugate Heat Transfer of Aviation Kerosene in Horizontal Tubes

Numerical Study of Fluid Flows and Heat Transfer of Aviation Kerosene with Consideration of Fuel Pyrolysis and Surface Coking at Supercritical Pressures

Numerical Study of Heat Transfer Characteristics of Downward Supercritical Kerosene Flow Inside Circular Tubes

Flow frictional resistance characteristics of kerosene RP-3 in horizontal circular tube at supercritical pressure

Viscosity Measurements of the H2–CO2, H2–CO2–CH4, and H2–H2O Mixtures and the H2–CO2–CH4–CO–H2O System at 280–924 K and 0.7–33.1 …

Characteristics of Flow Distribution of Aviation Kerosene in Parallel Pipes under Supercritical Pressure

Modeling and Simulation of Supercritical-Pressure Turbulent Heat Transfer of Aviation Kerosene with Detailed Pyrolytic Chemical Reactions

Heavy Oil Viscosity Measurements: Best Practices and Guidelines