Abstract:In this paper, we described the design and construction of a new two-capillary viscometer with several novel technical solutions for viscosity and density measurements. Our design, which is based on the low-pressure principle, featured numerous improvements in hardware and procedure that allowed the greatly extended range of pressure. The new design adopted a (2×2) capillary configuration, utilizing different combinations of four capillaries to enable viscosity measurements with a wide range of flow rates, temperatures, and pressures. The design temperature range is 213 K – 473 K, and the pressure range is up to 100 MPa. The viscometer was specifically designed for measuring the viscosity of pure CO2 and CO2-rich mixtures, addressing the scarcity of data in conditions relevant to carbon capture, transport, and storage (CCS). Our facility is capable of viscosity measurements in different thermodynamic states; gaseous, liquid, supercritical, and critical regions. A commercial densimeter is integrated to measure density under the same temperatures and pressures. We aimed for a total uncertainty target of better than 0.03%. The performance of the viscometer was validated by measurements with pure CO2 at 298.15 K and zero density. We observed a deviation of less than 0.03% between the reference viscosity of CO2 of this work and accurately calculated data using ab initio quantum mechanics with a standard uncertainty of 0.2%. Our primary focus in this paper was to provide a detailed description of the design and construction of the apparatus, emphasizing improvements and introducing new solutions to other research groups in constructing similar instruments suitable for low- and high-pressure viscosity measurements with high accuracy.

A New Method for Liquid Viscosity Measurements: Inclined-Tube Viscometry

A METHOD FOR LIQUID VISCOSITY COEFFICIENT MEASUREMENT USING INCLINED TUBE

Development of a Viscosity Measuring Device for Low Boiling Point Refrigerant Mixtures

A Online Capillary Method for Viscosity Measurement under High Temperature and Pressure

Study on Measurement of Liquid Viscosity Coefficient

Development of Viscosity Real-time Measurement System Based on Capillary Method

New Method for the Measurement of Liquid Viscosity Coefficient in Laboratory

Design and preliminary test of liquid phase pVT measurement system using constant-volume cell

Development of Vibrating-Wire Viscometer for Liquid at High Pressure

Improvement on Liquid Saturated Vapor Pressure Measurement

Liquid Viscosity Measurement Method in the Pressure Range of 0.1 ～ 0.5 MPa Based on Couette Rheometer

A New Capillary Viscometer for Volatile Liquid

Development and Verification of High Accuracy Apparatus for Solubility Measurement

Viscosity Measurement of Hydrocarbons Using a Two-Capillary Viscometer

A two-capillary viscometer for temperatures up to 473 K and pressures up to 100 MPa – operation and verification at low pressure

Viscosity Measurement of Endothermic Fuels at Temperatures from 303 K to 673 K and Pressures Up to 5.00 MPa

Viscosity Measurement of Aviation Kerosene RP-3 Using a Double-Capillary Viscometer with Equal Mass Flow

Liquid Viscosity Measurements for the Binary and Ternary Refrigerant Mixtures of R134a, R1234ze(E), and R1234yf

Design and Fabrication of a Microfluidic Viscometer Based on Electrofluidic Circuits

Viscosity Measurements of Hydrocarbon Fuel at Temperatures from (303.2 to 513.2) K and Pressures Up to 5.1 MPa Using a Two-Capillary Viscometer

Gaseous Viscosity Measurement for Several Refrigerant Mixtures