Abstract:Real-time measurement of heavy oil production is critical to ensure stable production. Due to the complex kinematic characteristics of heavy oil, existing methods cannot accurately measure its flow rate and water cut. In this paper, a novel method is proposed to measure the high water-cut heavy oil flow by using the differential pressure of the two-phase swirling flow in the pipe. For the swirling flow in the pipe, the radial differential pressure and the axial differential pressure exist simultaneously, which are very sensitive to the flow rate and water cut. The formation mechanism of the two kinds of differential pressure is analyzed theoretically, and their relationship with flow rate and water cut is studied by experiment and numerical simulation. The measurement model of heavy oil–water two-phase flow on the above relations is validated by field experiments. The radial differential pressure is only related to the two-phase flow rate, varying exponentially with the flow rate when the oil viscosity is greater than 10 000 mPa s. This characteristic is very useful for the heavy oil–water two-phase flow measurement. The axial differential pressure decreases with the increase in water cut in cases of water cut <85%, while it increases with the water cut in cases of water cut >85%. With the increase in water cut, the ratio of axial differential pressure to radial differential pressure first decreases and then increases. The relative errors of the established measurement model for flow rate and water cut are 0.19%–17.92% and 0.21%–15.5%, respectively, and more than 70% of the measurements with a relative error of less than 10%. The study of the heavy oil–water two-phase flow measurement method can optimize the measurement cost and accelerate the process of intelligent oilfield construction.

Oil-water two-phase flow measurement based on differential pressure

Experimental Studies on the Measurement of Oil-water Two-phase Flow

Oil-Gas-Water Three-Phase Flow Measurement Based on the Theory of Partial Separation

Investigation of Oil-Air Two-Phase Mass Flow Rate Measurement Using Venturi and Void Fraction Sensor

Oil-water two-phase flow measurement based on a hybrid flowmeter and dominant phase identification

Flowrate measurement of air-water two-phase flow using an Electrical Resistance Tomography sensor and a Venturi meter

Relationship between fluctuating differential pressure and void fraction of gas-liquid two-phase flow in Venturi tube

Air–water two-phase flow measurement using a Venturi meter and an electrical resistance tomography sensor

Mass Flow Measurement of Oil-Water Two-Phase Flow Based on Coriolis Flow Meter and SVM

Experimental Study on Performance of Turbine Flowmeter and Venturi Meter in Oil-Water Two-Phase Flow Measurement

OIL-WATER TWO-PHASE FLOW MEASUREMENT USING A VENTURI METER AND AN OVAL GEAR FLOW METER

Gas–oil two-phase flow measurement using an electrical capacitance tomography system and a Venturi meter

Measurement of high water-cut heavy oil flow based on differential pressure of swirling flow

Measurement of the Flow Rate and Volume Void Fraction of Gas-Liquid Bubble Flow Using A Vortex Flow Meter

A study of mass flow rate measurement based on the vortex shedding principle

A Flow Rate Measurement Method for Horizontal Oil-Gas-water Three-Phase Flows Based on Venturi Meter, Blind Tee, and Gamma-Ray Attenuation

Double parameter measurement of steam-water two-phase flow by using differential pressure noise of orifice

A New Method of Measuring the Oil–air–water Three-Phase Flow Rate

Flowrate measurement of vertical oil-gas-water slug flow based on basic temperature and differential pressure signals

Flow regime identification of oil-water two-phase flow based on HHT and SVM

Measurement of Pressure Fluctuation in Gas-Liquid Two-Phase Vortex Street