Abstract:Although the emerging 3D DRAM products can significantly improve the computing system performance, the relatively high cost is one of the most critical issues that prevent their wide real-life adoption. Intuitively, a strong memory fault tolerance can be leveraged to reduce the fabrication cost of DRAM dies, and the total cost will reduce if the fabrication cost saving can off-set the cost overhead of memory fault tolerance. Nevertheless, such a simple concept can be a practically viable option only for 3D DRAM because: (1) The stacked logic die can solely implement memory fault tolerance inside 3D DRAM chips, obviating any changes on the host CPUs and CPU-DRAM interfaces. (2) With the total ownership of both the logic die and DRAM dies inside 3D DRAM chips, DRAM manufacturers can fully exploit the potential to truly minimize the 3D DRAM bit cost. Following this intuition, we developed a 3D DRAM fault tolerance design strategy. It can achieve a very strong tolerance to weak DRAM cells at very small redundancy and latency overhead. The key is to cohesively leverage the detectability of weak cells and runtime configurability of error correction code (ECC) decoding. In addition, this design strategy can gracefully embrace the inaccuracy of weak cell detection (e. g., weak cell miss-detection and false-detection). We carried out thorough mathematical analysis, and the results show that, under the redundancy overhead of 1: 8 (same as today's ECC DIMM), this design strategy can tolerate the weak cell rate of as high as 10(-4) and 6 x 10(-5) if 100 and 90 percent of all the weak cells are known in prior. Using Micron's hybrid memory cube (HMC) 3D DRAM chips as the test vehicle, we evaluated the implementation cost and the results show that it only consumes less than 0.4 mm(2) (45 nm node) on the logic die. Using CPU and DRAM simulators, we further carried out simulations over a variety of computing benchmarks and the results show that this design solution only incurs less than 2 percent performance degradation on average.

A BISR Scheme for 3D Stacked Memory by Sharing Adjacent Redundancy Cells Across Dies

Yield Enhancement for 3D-Stacked Memory by Redundancy Sharing Across Dies

Fault clustering technique for 3D memory BISR.

Yield Optimization Technique for Three Dimensional Memory Based on Redundancy Sharing Among Adjacent Layers

A Stacking Scheme Using Adjacent Redundancy Across Dies for 3D-stacked Memory

A Die Selection and Matching Method for Yield Enhancement of 3D-Stacked Memories

Architecture design exploration of three-dimensional (3D) integrated DRAM

On Effective Through-Silicon Via Repair for 3-D-stacked ICs

Logic-DRAM co-design to efficiently repair stacked DRAM with unused spares

Redundant Vias Insertion for Performance Enhancement in 3D ICs.

Logic-DRAM Co-Design to Exploit the Efficient Repair Technique for Stacked DRAM

A 3D SoC Design for H.264 Application with On-Chip DRAM Stacking

Efficient built-in self-repair strategy for embedded SRAM with selectable redundancy

A Cross-Process Signal Integrity Analysis (CPSIA) Method and Design Optimization for Wafer-on-Wafer Stacked DRAM

Improving 3D DRAM Fault Tolerance Through Weak Cell Aware Error Correction.

On Effective Tsv Repair For 3d-Stacked Ics

An Effective TSV Self-Repair Scheme for 3D-Stacked ICs.

A Customized Design Of Dram Controller For On-Chip 3d Dram Stacking

A built-in self-repair design for RAMs with 2-D redundancy

Design of 3D DRAM and Its Application in 3D Integrated Multi-Core Computing Systems

Memory Grouping for the Built-In Self-Test of Three-Dimensional Integrated Circuits