Abstract:The reason that p-GaN gate normally-off high electron mobility transistor (HEMT) device is able to draw prevail interests is not only for its outstanding electric properties of low on-resistance and high thermal conductivity, but also for its applications under high frequency and high voltage. In HEMT devices, the setting of Al component in the AlGaN barrier layer is a key parameter to affect the formation of two-dimensional electron gas (2DEG) at the AlGaN/GaN heterojunction, and therefore directly determines the performance of the devices. This paper uses the Atlas module of the Silvaco-TCAD software to design and simulate p-GaN gate normally-off HEMT devices to investigate the effect of Al mole fraction content in the AlGaN barrier layer on the electrical performance, as well as the causes in terms of the conduction band energy structure diagram. The results show that the threshold voltage of the HEMT device decreases, the maximum saturation drain current increases, and the peak transductance of the HEMT device increases with increasing the Al content. In the off-state (zero gate voltage), the AlGaN/GaN potential well depth becomes deeper as the Al mole fraction increases, resulting in a lower driven force to rebuild the minimized 2DEG concentration in the GaN layer for switching from off-state to on-state, and this leads to a lower threshold voltage. While, in the on-state (5 V gate voltage), the deeper AlGaN/GaN potential well depth as the Al mole fraction increases, the higher of the 2DEG concentration of the GaN layer, leading to a higher maximum saturation output drain current. After optimization, the integrated electrical performance of the HEMT devices has been found best when the Al mole fraction content is about 0.25. The results obtained from the simulations are helpful for the experimental design of p-GaN gate normally-off HEMT devices

Performance Optimization of Lateral Algan/Gan Hemts with Cap Gate on 150-Mm Silicon Substrate

Study of GaN/AlGaN Air Structure Gate HEMTs with High Linearity for RF Applications

Simulation study on electrical properties of p-GaN gate normally-off HEMT devices affected by Al mole fraction in AlGaN barrier layer

Current-collapse Suppression and Leakage-Current Decrease in AlGaN/GaN HEMT by Sputter-Tan Gate-Dielectric Layer

Effect of Device Geometry on Static and Dynamic Performance of AlGaN/GaN-on-Si High Electron Mobility Transistor

Normally-OFF AlGaN/GaN-based HEMTs with Decreasingly Graded AlGaN Cap Layer

Simulation Design of a High-Breakdown-voltage P-Gan-gate GaN HEMT with a Hybrid AlGaN Buffer Layer for Power Electronics Applications

Influence of Transverse Geometry of Sidewall Gates on Characteristics of AlGaN/GaN Fin-HEMTs

Optimization of Contact Resistance and DC Characteristics for AlGaN/GaN HEMTs Utilizing Sub-10 nm Nanohole Etching

An Improved Design for E-Mode AlGaN/GaN HEMT with Gate Stack -Ga2o3/p-gan Structure

High-performance Normally off AlGaN/GaN High Electron Mobility Transistor with P-Type H-Bn Cap Layer

An AlGaN/GaN HEMT with a reduced surface electric field and an improved breakdown voltage

High-performance normally off p-GaN gate high-electron-mobility transistor with In 0.17 Al 0.83 N barrier layer design

Improved Algan/Gan Hemts Grown on Si Substrates Using Stacked Algan/Aln Interlayer by Mocvd

Study of the Leakage Current Suppression for Hybrid-Schottky/ohmic Drain AlGaN/GaN HEMT

An improved design for e-mode AlGaN/GaN HEMT with gate stack β-Ga2O3/p-GaN structure

Simulation and analysis of enhancement-mode AlGaN/GaN HEMT with P-I-N junction gate

The Effect Of The Gate-Drain Distance On High Frequency And Noise Performance For Algan/Gan Hemt

Low Leakage Current and High-Cutoff Frequency AlGaN/GaN MOSHEMT Using Submicrometer-Footprint Thermal Oxidized TiO2/NiO As Gate Dielectric

Reduced Reverse Gate Leakage Current for P‐gan Gate High‐Electron‐Mobility Transistors by a Surface‐Etching Method

Improvement Performance of p-GaN Gate High-Electron-Mobility Transistors with GaN/AlN/AlGaN Barrier Structure