Abstract:The reason that p-GaN gate normally-off high electron mobility transistor (HEMT) device is able to draw prevail interests is not only for its outstanding electric properties of low on-resistance and high thermal conductivity, but also for its applications under high frequency and high voltage. In HEMT devices, the setting of Al component in the AlGaN barrier layer is a key parameter to affect the formation of two-dimensional electron gas (2DEG) at the AlGaN/GaN heterojunction, and therefore directly determines the performance of the devices. This paper uses the Atlas module of the Silvaco-TCAD software to design and simulate p-GaN gate normally-off HEMT devices to investigate the effect of Al mole fraction content in the AlGaN barrier layer on the electrical performance, as well as the causes in terms of the conduction band energy structure diagram. The results show that the threshold voltage of the HEMT device decreases, the maximum saturation drain current increases, and the peak transductance of the HEMT device increases with increasing the Al content. In the off-state (zero gate voltage), the AlGaN/GaN potential well depth becomes deeper as the Al mole fraction increases, resulting in a lower driven force to rebuild the minimized 2DEG concentration in the GaN layer for switching from off-state to on-state, and this leads to a lower threshold voltage. While, in the on-state (5 V gate voltage), the deeper AlGaN/GaN potential well depth as the Al mole fraction increases, the higher of the 2DEG concentration of the GaN layer, leading to a higher maximum saturation output drain current. After optimization, the integrated electrical performance of the HEMT devices has been found best when the Al mole fraction content is about 0.25. The results obtained from the simulations are helpful for the experimental design of p-GaN gate normally-off HEMT devices

On the physical operation and optimization of the p-GaN gate in normally-off GaN HEMT devices

Simulation study on electrical properties of p-GaN gate normally-off HEMT devices affected by Al mole fraction in AlGaN barrier layer

Impact of Mg out-diffusion and activation on the p-GaN gate HEMT device performance

Gate and barrier layer design of E-mode GaN HEMT with p-GaN gate structure

On-chip AlGaN/GaN HEMTs with the Compatible Normally-off p-GaN Gate and Normally-on MIS Gate Fabrication Processes

Simulation and analysis of enhancement-mode AlGaN/GaN HEMT with P-I-N junction gate

Normally-off GaN HEMTs with InGaN P-Gate Cap Layer Formed by Polarization Doping

An improved design for e-mode AlGaN/GaN HEMT with gate stack β-Ga2O3/p-GaN structure

Analysis and modeling of the influence of gate leakage current on threshold voltage and subthreshold swing in p-GaN gate AlGaN/GaN high electron mobility transistors

A new gate design combined MIS and p-GaN gate structures for normally-off and high on-current operation

Enhancement-mode GaN HEMT using a combination structure of recessed-gate and p-GaN gate structure

Effect of Device Geometry on Static and Dynamic Performance of AlGaN/GaN-on-Si High Electron Mobility Transistor

An Improved Design for E-Mode AlGaN/GaN HEMT with Gate Stack -Ga2o3/p-gan Structure

Study on the Optimization of Off-State Breakdown Performance of P-Gan HEMTs

High-performance normally off p-GaN gate high-electron-mobility transistor with In 0.17 Al 0.83 N barrier layer design

Normally-off GaON/p-GaN Gate HEMTs with Selective Plasma Oxidation: from Structural Characterization, Performance Improvement to Physical Mechanism

Optimization of Two-Dimensional Electron Gases and I–V Characteristics for AlGaN/GaN HEMT Devices

High-performance Normally off AlGaN/GaN High Electron Mobility Transistor with P-Type H-Bn Cap Layer

Challenges and advancements in p-GaN gate based high electron mobility transistors (HEMTs) on silicon substrates

Maximizing the Performance of 650-V P-Gan Gate HEMTs: Dynamic RON Characterization and Circuit Design Considerations

A Normally-off P-Gate AlGaN/GaN HEMT for High Power Application