Abstract:The reason that p-GaN gate normally-off high electron mobility transistor (HEMT) device is able to draw prevail interests is not only for its outstanding electric properties of low on-resistance and high thermal conductivity, but also for its applications under high frequency and high voltage. In HEMT devices, the setting of Al component in the AlGaN barrier layer is a key parameter to affect the formation of two-dimensional electron gas (2DEG) at the AlGaN/GaN heterojunction, and therefore directly determines the performance of the devices. This paper uses the Atlas module of the Silvaco-TCAD software to design and simulate p-GaN gate normally-off HEMT devices to investigate the effect of Al mole fraction content in the AlGaN barrier layer on the electrical performance, as well as the causes in terms of the conduction band energy structure diagram. The results show that the threshold voltage of the HEMT device decreases, the maximum saturation drain current increases, and the peak transductance of the HEMT device increases with increasing the Al content. In the off-state (zero gate voltage), the AlGaN/GaN potential well depth becomes deeper as the Al mole fraction increases, resulting in a lower driven force to rebuild the minimized 2DEG concentration in the GaN layer for switching from off-state to on-state, and this leads to a lower threshold voltage. While, in the on-state (5 V gate voltage), the deeper AlGaN/GaN potential well depth as the Al mole fraction increases, the higher of the 2DEG concentration of the GaN layer, leading to a higher maximum saturation output drain current. After optimization, the integrated electrical performance of the HEMT devices has been found best when the Al mole fraction content is about 0.25. The results obtained from the simulations are helpful for the experimental design of p-GaN gate normally-off HEMT devices

Gate and barrier layer design of E-mode GaN HEMT with p-GaN gate structure

Enhancement-mode GaN HEMT using a combination structure of recessed-gate and p-GaN gate structure

An improved design for e-mode AlGaN/GaN HEMT with gate stack β-Ga2O3/p-GaN structure

An Improved Design for E-Mode AlGaN/GaN HEMT with Gate Stack -Ga2o3/p-gan Structure

Review on Main Gate Characteristics of P-Type GaN Gate High-Electron-Mobility Transistors

Simulation study on electrical properties of p-GaN gate normally-off HEMT devices affected by Al mole fraction in AlGaN barrier layer

Simulation and analysis of enhancement-mode AlGaN/GaN HEMT with P-I-N junction gate

Threshold Voltage Modulation and Gate Leakage Suppression of Enhancement-Mode GaN HEMT by Metal/Insulator/p-GaN Gate Structure

On the physical operation and optimization of the p-GaN gate in normally-off GaN HEMT devices

p-GaN Gate HEMTs With 10.6 V Maximum Gate Drive Voltages by Mg Doping Engineering

Normally-off GaN HEMTs with InGaN P-Gate Cap Layer Formed by Polarization Doping

Simulation Study of the Use of AlGaN/GaN Ultra-Thin-Barrier HEMTs with Hybrid Gates for Achieving a Wide Threshold Voltage Modulation Range

High-performance Normally off AlGaN/GaN High Electron Mobility Transistor with P-Type H-Bn Cap Layer

Normally-Off Schottky-Gate P-Gan HEMTs with Enhanced Irradiation Hardness

A Fin-p-GaN HEMT for High Threshold Voltage with Enhanced Stability.

Simulation Design of a High-Breakdown-voltage P-Gan-gate GaN HEMT with a Hybrid AlGaN Buffer Layer for Power Electronics Applications

Effects of Gate Work Function on E-mode AlGaN/GaN HEMTs with Stack Gate Β-Ga2o3/p-gan Structure

Wide-range-adjusted threshold voltages for E-mode AlGaN/GaN HEMT with a p-SnO cap gate

Gate Leakage Suppression and Breakdown Voltage Enhancement in p-GaN HEMTs using Metal/Graphene Gates

Normally-off GaON/p-GaN Gate HEMTs with Selective Plasma Oxidation: from Structural Characterization, Performance Improvement to Physical Mechanism

High-performance normally off p-GaN gate high-electron-mobility transistor with In 0.17 Al 0.83 N barrier layer design